求108B JATG刷机方法和固件

xjx***

S29芯片...求联通固件及JATG刷机方法

xjx***

接TTL线,开机后的信息:
FSB v0.06 PLL w ln p08 zi

ZXV10 HGW bootloader V1.8

SDRAM size = 0x2000000-------->
Processor clock speed 264.0MHz
FLASH size = 0x1000000-------->
Finding flashfs partition ...@ offset 00540000
Finding flashfs partition ...@ offset 00620000
2 partition found
Boot from image B @ offset 00620000
done.

Image 'image' is a Linux kernel
Trying to load initrd...none found
Calling Configure_NVS_FromFile.

LZMA 4.05
00bXLinux version 2.6.11.12 (xia@localhost.localdomain) (gcc version 4.0.1) #137 Tue Jul 8 15:56:26 CST 2008
CPU: ARM1026EJ-Sid(wb)B [4106a262] revision 2 (ARMv5TEJ)
CPU0: D VIVT write-back cache
CPU0: I cache: 16384 bytes, associativity 4, 32 byte lines, 128 sets
CPU0: D cache: 8192 bytes, associativity 4, 32 byte lines, 64 sets
Machine: Solos CX46xx, unknown variant
Memory policy: ECC disabled, Data cache writeback
Built 1 zonelists
Kernel command line: console=ttyS0 root=31:4 rw mem=31M mtdparts=phys_mapped_flash:256k(boot),1024k(kernel),4992k(JFFS2),1024k(k2),4992k(J2),-(CT) rootfstype=jffs2
init_dma not supported
PID hash table entries: 128 (order: 7, 2048 bytes)
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Memory: 31MB = 31MB total
Memory: 28992KB available (1831K code, 492K data, 76K init)
Mount-cache hash table entries: 512 (order: 0, 4096 bytes)
CPU: Testing write buffer coherency: ok
NET: Registered protocol family 16
Generic PHY: Registered new driver
SCSI subsystem initialized
usbcore: registered new driver hub
NetWinder Floating Point Emulator V0.97 (double precision)
JFFS2 version 2.2. (C) 2001-2003 Red Hat, Inc.
Initializing Cryptographic API
Ledkey Driver Version 0.0.1.
ledkey : ===== ledkey_init =====
init watchdog!!!
zteinfo_init
Solos on-chip UART init.
ttyS0 at I/O 0x0 (irq = 29) is a Solos UART
io scheduler noop registered
RTL18305SD: Registered new driver
PPP generic driver version 2.4.2
NET: Registered protocol family 24
physmap flash device: 1000000 at 38000000
phys_mapped_flash: Found 1 x16 devices at 0x0 in 8-bit bank
Amd/Fujitsu Extended Query Table at 0x0040
phys_mapped_flash: CFI does not contain boot bank location. Assuming top.
number of CFI chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
Creating 8 MTD partitions on "phys_mapped_flash":
0x00000000-0x01000000 : "flash"
0x00000000-0x00020000 : "Bootloader"
0x00020000-0x00040000 : "config"
0x00540000-0x00620000 : "kernel"
0x00040000-0x00540000 : "filesystem"
0x00620000-0x00700000 : "kernel2"
0x00700000-0x00c00000 : "filesystem2"
0x00c00000-0x01000000 : "ct-jffs2"
Solos-W EHCI starting up...
solosW-ehci usb00: Solos USB 2.0
solosW-ehci usb00: irq 9, pci mem ff800100
solosW-ehci usb00: new USB bus registered, assigned bus number 1
solosW-ehci usb00: park 0
solosW-ehci usb00: USB 0.0 initialized, EHCI 1.00, driver 10 Dec 2004
usb usb1: Product: Solos USB 2.0
usb usb1: Manufacturer: Linux 2.6.11.12 ehci_hcd
usb usb1: SerialNumber: Solos EHCI
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 1 port detected
INTR_MASK 37, 37
Initializing USB Mass Storage driver...
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
u32 classifier
    OLD policer on
NET: Registered protocol family 2
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
IPv4 over IPv4 tunneling driver
ip_conntrack version 2.1 (248 buckets, 1984 max) - 320 bytes per conntrack
ip_tables: (C) 2000-2002 Netfilter core team
ip_conntrack_rtsp v0.01 loading
ip_nat_rtsp v0.01 loading
netfilter PSD loaded - (c) astaro AG
Initializing IPsec netlink socket
NET: Registered protocol family 1
NET: Registered protocol family 17
NET: Registered protocol family 15
Please set the MAC Address for the WAN Bridge.
Set the Environment variable 'wan_br_mac'.
MAC Address should be in the following format: xx.xx.xx.xx.xx.xx
Ebtables v2.0 registered
NET: Registered protocol family 8
NET: Registered protocol family 20
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
VFS: Mounted root (jffs2 filesystem).
Freeing init memory: 76K
init started:  BusyBox v1.01 (2008.07.08-07:58+0000) multi-call binary
Starting pid 133, console /dev/ttyS0: '/etc/rc'
Alarm clock
            Loading Conexant BSP...
Using /lib/modules/2.6.11.12/kernel/drivers/net/arm/solos_ethernet.ko
solos_ethernet: module license 'unspecified' taints kernel.
rtl8306sd_hw_init
rtl8306_switch_init
rtl8306_init  sucess!
rtl8306_initQos  sucess!
rtl8306_setCPUPort  sucess!
rtl8306_initVlan  sucess!
rtl8306 IGMP snooping enabled!
rtl8306sd_hw_init
rtl8306sd_hw_init
rtl8306sd_hw_init
rtl8306sd_hw_init
rtl8306sd_hw_init
rtl8306sd_hw_init
solos_eth_mii: probed
Using /lib/hsl_mod_gpl.o
Using /lib/cnxt_fiq.o
Using /lib/cnxt_drv.o
BASE MAC ADDRESS 00:11:22:33:44:55

Starting Conexant drivers
.
Quantum v1.01
msc16 loaded

'create dev file with mknod /dev/adet_char c 244 0'.
starting task turbo_WhipTask
DSL MSC16 imem 4096, dmem 2048

DSL MSC16 version 1.3
msc16_load_file returned 0
sram_buffer : 0xffa01360 addr : 0x70001360
Passing command buffer 70001360 to MSC16

Conexant drivers started
Using /lib/wlan_wsc.ko
MY INIT Called
Using /lib/modules/2.6.11.12/kerRUNNING Timer started
nel/arch/arm/mach-solos/solosw_defaultrestore.ko
enable virtual port

value is 20001

value is 30002

value is 40004

value is 50008
Loading Wireless ...
Reading True PDA ...
Using /lib/stun_ahb.ko
DRIVER VERSION: 3.0
---dsl is off--
Timeout waiting for ready int bit
ERROR:failed to upload the firmware
ERROR: sm_drv_stun_ahb could not start SHoCMAC on SOLOS-WLC
insmod: cannot insert `/lib/stun_ahb.ko': Operation not permitted (-1): Operation not permitted
---dsl is off--

xjx***

无人关注啊..看业是要丢了