zy900114 发表于 2013-2-15 22:15
对!
论坛果然高手云集,我短接了496,现在确实先死正常了。
请帮我看看启动信息里面有些什么错误,为什么现在就不能正常启动了呢??
下面就是没做任何处理的全部启动信息。。
U-Boot 1.1.4 (Feb 1 2010 - 11:00:47)
AP99 (ar7241 - Virian) U-boot
DRAM:
sri
ar7240_ddr_initial_config(133): virian ddr1 init
#### TAP VALUE 1 = 0xf, 2 = 0x10 [0x0: 0x1f]
32 MB
id read 0x100000ff
sector count = 64
Flash: 4 MB
Using default environment
In: serial
Out: serial
Err: serial
Net: ag7240_enet_initialize...
No valid address in Flash. Using fixed address
No valid address in Flash. Using fixed address
Virian MDC CFG Value ==> 4
: cfg1 0xf cfg2 0x7014
eth0: 00:03:7f:09:0b:ad
eth0 up
Virian MDC CFG Value ==> 4
: cfg1 0xf cfg2 0x7214
eth1: 00:03:7f:09:0b:ad
ATHRS26: resetting s26
ATHRS26: s26 reset done
eth1 up
eth0, eth1
Autobooting in 1 seconds
## Booting image at 9f020000 ...
Uncompressing Kernel Image ... OK
Starting kernel ...
OpenWrt kernel loader for AR7XXX/AR9XXX
Copyright (C) 2011 Gabor Juhos <juhosg@openwrt.org>
Looking for OpenWrt image... found at 0xbf022000
Decompressing kernel... done!
Starting kernel at 80060000...
[ 0.000000] Linux version 3.3.8 (kitt@joseph-ThinkCentre) (gcc version 4.6.3 20120201 (prerelease) (Linaro GCC 4.6-2012.02) ) #1 Sat Jul 21 04:06:05 CST 2012
[ 0.000000] bootconsole [early0] enabled
[ 0.000000] CPU revision is: 00019374 (MIPS 24Kc)
[ 0.000000] SoC: Atheros AR7241 rev 1
[ 0.000000] Clocks: CPU:400.000MHz, DDR:400.000MHz, AHB:200.000MHz, Ref:5.000MHz
[ 0.000000] Determined physical RAM map:
[ 0.000000] memory: 02000000 @ 00000000 (usable)
[ 0.000000] Initrd not found or empty - disabling initrd
[ 0.000000] Zone PFN ranges:
[ 0.000000] Normal 0x00000000 -> 0x00002000
[ 0.000000] Movable zone start PFN for each node
[ 0.000000] Early memory PFN ranges
[ 0.000000] 0: 0x00000000 -> 0x00002000
[ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128
[ 0.000000] Kernel command line: board=TL-WR841N-v7 console=ttyS0,115200 rootfstype=squashfs,jffs2 noinitrd
[ 0.000000] PID hash table entries: 128 (order: -3, 512 bytes)
[ 0.000000] Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
[ 0.000000] Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
[ 0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
[ 0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
[ 0.000000] Writing ErrCtl register=00000000
[ 0.000000] Readback ErrCtl register=00000000
[ 0.000000] Memory: 29276k/32768k available (2096k kernel code, 3492k reserved, 398k data, 204k init, 0k highmem)
[ 0.000000] SLUB: Genslabs=9, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
[ 0.000000] NR_IRQS:51
[ 0.000000] Calibrating delay loop... 265.42 BogoMIPS (lpj=1327104)
[ 0.080000] pid_max: default: 32768 minimum: 301
[ 0.080000] Mount-cache hash table entries: 512
[ 0.090000] NET: Registered protocol family 16
[ 0.090000] gpiochip_add: registered GPIOs 0 to 17 on device: ath79
[ 0.100000] MIPS: machine is TP-LINK TL-WR841N/ND v7
[ 0.500000] registering PCI controller with io_map_base unset
[ 0.510000] bio: create slab <bio-0> at 0
[ 0.520000] PCI host bridge to bus 0000:00
[ 0.520000] pci_bus 0000:00: root bus resource [mem 0x10000000-0x13ffffff]
[ 0.530000] pci_bus 0000:00: root bus resource [io 0x0000]
[ 0.530000] pci 0000:00:00.0: fixup device configuration
[ 0.540000] pci 0000:00:00.0: BAR 0: assigned [mem 0x10000000-0x1000ffff 64bit]
[ 0.540000] pci 0000:00:00.0: using irq 40 for pin 1
[ 0.550000] Switching to clocksource MIPS
[ 0.550000] NET: Registered protocol family 2
[ 0.560000] IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.560000] TCP established hash table entries: 1024 (order: 1, 8192 bytes)
[ 0.570000] TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.570000] TCP: Hash tables configured (established 1024 bind 1024)
[ 0.580000] TCP reno registered
[ 0.580000] UDP hash table entries: 256 (order: 0, 4096 bytes)
[ 0.590000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[ 0.600000] NET: Registered protocol family 1
[ 0.620000] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[ 0.620000] JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
[ 0.640000] msgmni has been set to 57
[ 0.640000] io scheduler noop registered
[ 0.640000] io scheduler deadline registered (default)
[ 0.650000] Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
[ 0.680000] serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A
[ 0.680000] console [ttyS0] enabled, bootconsole disabled
[ 0.680000] console [ttyS0] enabled, bootconsole disabled
[ 0.700000] m25p80 spi0.0: found w25q32, expected m25p80
[ 0.700000] m25p80 spi0.0: w25q32 (4096 Kbytes)
[ 0.710000] 5 tp-link partitions found on MTD device spi0.0
[ 0.710000] Creating 5 MTD partitions on "spi0.0":
[ 0.720000] 0x000000000000-0x000000020000 : "u-boot"
[ 0.730000] 0x000000020000-0x000000100a00 : "kernel"
[ 0.730000] mtd: partition "kernel" must either start or end on erase block boundary or be smaller than an erase block -- forcing read-only
[ 0.740000] 0x000000100a00-0x0000003f0000 : "rootfs"
[ 0.750000] mtd: partition "rootfs" must either start or end on erase block boundary or be smaller than an erase block -- forcing read-only
[ 0.760000] mtd: partition "rootfs" set to be root filesystem
[ 0.770000] mtd: partition "rootfs_data" created automatically, ofs=390000, len=60000
[ 0.780000] 0x000000390000-0x0000003f0000 : "rootfs_data"
[ 0.790000] 0x0000003f0000-0x000000400000 : "art"
[ 0.790000] 0x000000020000-0x0000003f0000 : "firmware"
[ 0.820000] ag71xx_mdio: probed
[ 0.820000] eth0: Atheros AG71xx at 0xba000000, irq 5
[ 1.380000] eth0: Found an AR7240/AR9330 built-in switch
[ 2.410000] eth1: Atheros AG71xx at 0xb9000000, irq 4
[ 2.960000] ag71xx ag71xx.0: eth1: connected to PHY at ag71xx-mdio.1:04 [uid=004dd041, driver=Generic PHY]
字数超限了,砍掉一节放到下一楼 |