|
|
ARRIS SBR-AC3200P
------------------------------------------------------------
------------------------------------------------------------
------------------------------------------------------------
------------------------------------------------------------
------------------------------------------------------------
------------------------------------------------------------
------------------------------------------------------------
------------------------------------------------------------
------------------------------------------------------------
------------------------------------------------------------
------------------------------------------------------------
------------------------------------------------------------
------------------------------------------------------------
------------------------------------------------------------
TTL 信息如下：求个固件！！！
-----------------------------------------------------------------------------------------------------------------------------
Decompressing...done
CFE version 7.14.43.25 (r) based on BBP 1.0.37 for BCM947XX (32bit,SP,)
Build Date: Mon Jan 4 16:34:43 CST 2016 (coda@xDSL-compiler)
Copyright (C) 2000-2008 Broadcom Corporation.
Init Arena
Init Devs.
Total size: 128MB
Block size: 128KB
Page Size: 2048B
OOB Size: 64B
Sector size: 512B
Spare size: 16B
ECC level: 4-bit
Boot partition size = 262144(0x40000)
DDR Clock: 800 MHz
Info: DDR frequency set from clkfreq=1000,*800*
et2: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 7.14.43.25 (r)
CPU type 0x0: 1000MHz
Tot mem: 262144 KBytes
CFE mem: 0x00F00000 - 0x017AF7E0 (9107424)
Data: 0x00F56A10 - 0x00F57030 (1568)
BSS: 0x00F57040 - 0x00FAD7E0 (354208)
Heap: 0x00FAD7E0 - 0x017AD7E0 (8388608)
Stack: 0x017AD7E0 - 0x017AF7E0 (8192)
Text: 0x00F00000 - 0x00F4BC80 (310400)
Init sc_boot.
Device eth0: hwaddr 74-EA-**-**-**-**, ipaddr 192.168.1.1, mask 255.255.255.0
gateway not set, nameserver not set
[dual] check_trx: nflash1.trx
Loader:raw Filesys:tftp Dev:eth0 File:: Options null)
Loading: Failed.
Could not load :: Timeout occured
[dual] boot cmd = boot -raw -z -addr=0x8000 -max=0xef8000 nflash0.os:
Loader:raw Filesys:raw Dev:nflash0.os File: Optionsnull)
Loading: ...................... 5403392 bytes read
Entry at 0x00008000
Closing network.
Starting program at 0x00008000
console [ttyS0] enabled, bootconsole disabled
serial8250.0: ttyS1 at MMIO 0x18000400 (irq = 117) is a 16550
brd: module loaded
loop: module loaded
pflash: found no supported devices
bcmsflash: found no supported devices
img_boot=(null) imag_1st_offset=(null) imag_2nd_offset=(null)
Boot partition size = 524288(0x80000)
[dual] img1 boot -> linux offset = 0x20,0000
lookup_nflash_rootfs_offset: offset = 0x200000
nflash: squash filesystem with lzma found at block 33
[dual] img1 boot ->rootfs offset = 0x42988c
Creating 4 MTD partitions on "nflash":
0x000000000000-0x000000080000 : "boot"
0x000000080000-0x000000200000 : "nvram"
0x000000200000-0x000002000000 : "linux"
0x00000042988c-0x000002000000 : "rootfs"
PPP generic driver version 2.4.2
PPP MPPE Compression module registered
NET: Registered protocol family 24
usbcore: registered new interface driver usblp
Initializing USB Mass Storage driver...
usbcore: regis|ered new interface driver usb-storage
USB Mass Storage support registered.
u32 classifier
Actions configured
Netfklter messages via NETLINK v0.30.
nf_conntrack version 0.5.0 (3972 buckets, 15888 max)
ctnetlink v0.93: registering with nfnetlink.
xt_time: kernel timezone is -0000
ip_tables: (C) 2000-2006 Netfilter Core Team
TCP cubic registered
NET: Registered protocol family 10
ip6_tables: (C) 2000-2006 Netfilter Core Team
IPv6 over IPv4 tunneling driver
NET: Registered protocol family 17
L2TP core driver, V2.0
PPPoL2TP kernel driver, V2.0
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <dXWV
ɕ▒▒▒ѹcom>
Northstar brcmnand NAND Flash Controller driver, Version 0.1 (c) Broadcom Inc. 2012
NAND device: Manufacturer ID: 0xc2, Chip ID: 0xf1 (Unknown NAND 128MiB 3,3V 8-bit)
Spare area=64 eccbytes 28, ecc bytes located at:
9 10 11 12 13 14 15 25 26 27 28 29 30 31 41 42 43 44 45 46 47 57 58 59 60 61 62 63
Available 35 bytes at (off,len):
(1,8) (16,9) (32,9) (48,9) (0,0) (0,0) (0,0) (0,0)
Scanning device for bad blocks
Options: NO_AUTOINCR,NO_READRDY,
Creating 1 MTD partitions on "brcmnand":
0x000007000000-0x000008000000 : "brcmnand"
Creating 1 MTD partitions on "brcmnand":
0x000000200000-0x000002000000 : "image1"
Creating 1 MTD partitions on "brcmnand":
0x000002000000-0x000003e00000 : "image2"
Creating 1 MTD partitions on "brcmnand":
0x000006800000-0x000006a00000 : "env"
Creating 1 MTD partitions on "brcmnand":
0x000003800000-0x000005800000 : "mt"
VFS: Mounted root (squashfs filesystem) readonly on device 31:3.
devtmpfs: mounted
Freeing init memory: 232K
/tmp/media/nand/config.tgz: No▒▒ס▒file or directory
/sbin/hotplug2: No such file or directory
insmod: ipv6.ko: no module by that name found
insmod: bcm57xx.ko: no module by that name found
hotplug detected product: 1d6b/3/206
hotplug detected product: 1d6b/3/206
hotplug detected product: 1d6b/2/206
hotplug detected product: 1d6b/2/206
hotplug detected product: 1d6b/1/206
hotplug detected product: 1d6b/1/226
GMAC3 not supported...
WARNING: console log level set to 1
eth1: WLC_SET_VAR(chanspec): Invalid argument
eth1: WLC_SET_VAR(ampdu_retry_limit_tid): Operation not supported
eth1: WLC_SET_VAR(ampdu_retry_limit_tid): Operation not supported
eth1: WLC_SET_VAR(ampdu_retry_limit_tid): Operation not supported
eth1: WLC_SET_VAR(ampdu_retry_limit_tid): Operation not supported
dth1: WLC_SET_VAR(ampdu_retry_limit_tid): Operation not supported
eth1: WLC_SET_VAR(ampdu_retry_limit_tid): Operation not supported
eth1: WLC_SET_VAR(ampdu%▒▒▒▒}▒▒▒▒▒}ѥ▒▒: Operation not supported
eth1: WLC_SET_VAR(ampdu_retry_limit_tid): Operation not supported
eth1: WLC_SET_VAR(ampdu_rr_retry_limit_tid): Operation not Supported
eth1: WLC_SET_VAR(ampdu_rr_retry_limit_tid): Operation not supported
eth1: WLC_SET_VAR(ampdu_rr_retry_limit_tid): Operation not supported
eth1: WLC_SET_VAR(ampdu_rr_retry_limit_tid): Operation not supported
eth1: WLC_SET_VAR(ampdu_rr_retry_limit_tid): Operation not supported
eth1: WLC_SET_VAR(ampdu_rr_retry_limit_tid): Operation not supported
eth1: WLC_SET_VAR(ampdu_rr_retry_limit_tid): Operation not supported
eth1: WLC_SET_VAR(ampdu_rr_retry_limit_tid): Operation not supported
eth1: WLC_SET_VAR(avg_dma_xfer_rate): Operation not supported
eth1: cmd=64: Operation not supported
eth2: cmd=231: Invalid argument
eth2: WLC_SET_VAR(chanspec): Invalid argument
eth2: WLC_SET_VAR(ampdu_retry_limit_tid): Operation not supported
eth2: WLC_SET_VAR(ampdu_retry_limit_tid): Operation not supported
eth2: WLC_SET_VAR(ampdu_retry_limit_tid): Operation not supported
eth2: WLC_SET_VAR(ampdu_retry_limit_tid): Operation not supported
eth2: WLC_SET_VAR(ampdu_retry_limit_tid): Operation not supported
eth2: WLC_SET_VAR(ampdu_retry_limit_tid): Operation not supported
eth2: WLC_SET_VAR(ampdu_retry_limit_tid): Operation not supported
eth2: WLC_SET_VAR(ampdu_retry_limit_tid): Operation not supported
eth2: WLC_SET_VAR(ampdu_rr_retry_limit_tid): Operation not supported
eth2: WLC_SET_VAR(ampdu_rr_retry_limit_tid): Operation not supported
eth2: WLC_SET_VAR(ampdu_rr_retry_limit_tid): Operation not supported
eth2: WLC_SET_VAR(ampdu_rr_retry_limit_tid): Operation not supported
eth2: WLC_SET_VAR(ampdu_rr_retry_limit_tid): Operation not supported
eth2: WLC_SET_VAR(ampdu_rr_retry_limit_tid): Operation not supported
eth2: WLC_SET_VAR(ampdu_rr_retry_limit_tid): Operation not supported
eth2: WLC_SET_VAR(ampdu_rr_retry_limit_tid): Operation not supported
eth2: WLC_SET_VAR(avg_dma_xfer_rate): Operation not supported
eth2: cmd=64: Operation not supported
dhcp6s: No such file or directory
info, udhcp server (v0.9.8) started
telnetd: starting
port: 23; interface: br0; login program: /bin/sh
killall: hspotap: no process killed
### wps_wfi_init(): <wl0_wfi_enable=(null)><wl1_wfi_enable=(null)>WFI is not enabled ###
BSD is not enabled: 0=0
Hotspot2.0 - version 7.14.43.25 (r)
Copyright Broadcom Corporation
acsd: selected DFS-exit channel spec: 0xd0a5
acsd: selected channel spec: 0xd0a5
killall: smbd: no process killed
rm: cannot remove '/tmp/samba/private/passdb.tdb': No such file or directory
rm: cannot remove '/tmp/samba/private/secrets.tdb': No such file or directory
Hit enter to continue...connect: Network is unreachable
Hit enter to continue...
BusyBox v1.7.2 (2015-07-29 16:48:46 CST) built-in shell (ash)
Enter 'help' for a list of built-in commands.
#
#
#
#
# hotplug detected product: 8644/800a/100
hotplug detected product: 8644/800a/100
# Stop bcmmserver.
hotplug detected product: 8644/800a/100
hotplug detected product: 8644/800a/100
Stop bcmmserver.
# hotplug detected product: 8644/800a/100
hotplug detected product: 8644/800a/100
# Stop bcmmserver.
hotplug detected product: 8644/800a/100
hotplug detected product: 8644/800a/100
Stop bcmmserver.
# acsd: selected channel spec: 0xd0a5
acsd: selected channel spec: 0xd0a5
----------------------------------------------------------------------------------
刷个DD固件可以启动了..
但是么有有线了... 真悲哀....
水平有限.....
算了吧，不想折腾了....
有能力玩的可以转让....
https://2.taobao.com/item.htm?id=565083125426&spm=a1z38n.10677092.0.0.182e1debtp2u2b
补充内容 (2018-4-7 00:17):
细节图在这里...
https://www.right.com.cn/forum/thread-310716-1-1.html |
|
/1 
IP卡
狗仔卡
发表于 2018-4-7 00:14
置顶卡
沉默卡
喧嚣卡
顶贴卡
显身卡
