谁会修614v8？同时求购H618B 2台

dm4***

614一改8m/32m，刷wayos可以，TTL＝64无法进入界面，无线有wayos信号但是一样不能进入ie，TTL信息如下：

CFE version 1.0.37 for BCM947XX (32bit,SP,LE)
Build Date: Tue Oct  9 13:28:26 EDT 2007 (tornado@dd-wrt.com)
Copyright (C) 2000,2001,2002,2003 Broadcom Corporation.

Initializing Arena
Initializing Devices.
Boot partition size = 262144(0x40000)
et0: Broadcom BCM47xx 10/100 Mbps Ethernet Controller 4.150.10.5
CPU type 0x29029: 240MHz
Total memory: 32768 KBytes

Total memory used by CFE:  0x80700000 - 0x807977D0 (620496)
Initialized Data:          0x8072E860 - 0x80730FB0 (10064)
BSS Area:                  0x80730FB0 - 0x807317D0 (2080)
Local Heap:                0x807317D0 - 0x807957D0 (409600)
Stack Area:                0x807957D0 - 0x807977D0 (8192)
Text (code) segment:       0x80700000 - 0x8072E860 (190560)
Boot area (physical):      0x00798000 - 0x007D8000
Relocation Factor:         I:00000000 - D:00000000

Device eth0:  hwaddr 01-38-06-09-01-38, ipaddr 192.168.1.1, mask 255.255.255.0
        gateway not set, nameserver not set
Loader:raw Filesys:tftp Dev:eth0 File:: Optionsnull)
Loading: Failed.
Could not load :: Timeout occured
Loader:raw Filesys:raw Dev:flash0.os File: Optionsnull)
Loading: ...... 1880064 bytes read
Entry at 0x80001000
Closing network.
Starting program at 0x80001000
CPU revision is: 00029029
Primary instruction cache 16kb, linesize 16 bytes (4 ways)
Primary data cache 16kb, linesize 16 bytes (2 ways)
Linux version 2.4.20 (root@linux) (gcc version 3.2.3 with Broadcom modifications) #36 Wed Oct 27 03:17:37 PDT 2010
Setting the PFC to its default value
Determined physical RAM map:
memory: 02000000 @ 00000000 (usable)
On node 0 totalpages: 8192
zone(0): 8192 pages.
zone(1): 0 pages.
zone(2): 0 pages.
Kernel command line: root=/dev/mtdblock2 noinitrd console=ttyS0,115200
CPU: BCM5354 rev 3 at 240 MHz
Calibrating delay loop... 237.56 BogoMIPS
Memory: 29268k/32768k available (1628k kernel code, 3500k reserved, 112k data, 72k init, 0k highmem)
Dentry cache hash table entries: 4096 (order: 3, 32768 bytes)
Inode cache hash table entries: 2048 (order: 2, 16384 bytes)
Mount-cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer-cache hash table entries: 1024 (order: 0, 4096 bytes)
Page-cache hash table entries: 8192 (order: 3, 32768 bytes)
Checking for 'wait' instruction...  unavailable.
POSIX conformance testing by UNIFIX
PCI: no core
PCI: Fixing up bus 0
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
devfs: v1.12c (20020818) Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x1
squashfs: version 3.0 (2006/03/15) Phillip Lougher
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled
ttyS00 at 0xb8000300 (irq = 3) is a 16550A
ttyS01 at 0xb8000400 (irq = 0) is a 16550A
HDLC line discipline: version $Revision: 1.1.1.4 $, maxframe=4096
N_HDLC line discipline registered.
PPP generic driver version 2.4.2
Universal TUN/TAP device driver 1.5 (C)1999-2002 Maxim Krasnyansky
pflash: found no supported devices
Creating 5 MTD partitions on "sflash":
0x00000000-0x00040000 : "pmon"
0x00040000-0x007f0000 : "linux"
0x001034e0-0x003d0000 : "rootfs"
0x003d0000-0x007f0000 : "jffs2"
0x007f0000-0x00800000 : "nvram"
jhl_order: (C) 2007 jianhl
jhl_share_init  start
jhl_share_init ok
ksys_log : create a netlink socket ok!
arp_sys  start
jhl_arp_sys_init ok
jhl hostinfo init
jhl_hixz_init start
jhl_mqos_init start
jhl_fenlei_init start
jhl_conn_init start
jhl_conn_init end
jhl_dhcp_pool_init start
jhl_dhcp_pool_init ok
jhl_dns_cache_init ok
jhl_acc_init start
urlrd_init: (C) 2009 jianhl
jhl_pppoe_init start
jhl_pppoe_init ok
jhl_user_init start
jhl_user_init ok
jhl_session_init start
jhl_session_init ok
jhl_msg_init start
qj_init: (C) 2007 jianhl
mroute_init: (C) 2009 jianhl
jhl_jb_init start
jhl_ddos_init ok
jhlradius : create a netlink socket ok!
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 2048 bind 4096)
Linux IP multicast router 0.06 plus PIM-SM
ip_conntrack version 2.1 (8092 buckets, 4096 max) - 496 bytes per conntrack
ip_tables: (C) 2000-2002 Netfilter core team
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
NET4: Ethernet Bridge 008 for NET4.0
802.1Q VLAN Support v1.7 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
VFS: Mounted root (squashfs filesystem) readonly.
Mounted devfs on /dev
Freeing unused kernel memory: 72k freed


Hit ENTER for console...

Algorithmics/MIPS FPU Emulator v1.5
sh: inithd: not found
Saving...
eth0: Broadcom BCM47xx 10/100 Mbps Ethernet Controller 4.130.25.0
eth1: Broadcom BCM4318 802.11 Wireless Controller 4.130.19.0
vlan0: dev_set_promiscuity(master, 1)
device eth0 entered promiscuous mode
device vlan0 entered promiscuous mode
device eth1 entered promiscuous mode
eth2: No such device
eth3: No such br0: port 2(eth1) entering listening state
device
br0: port 1(vlan0) entering listening state
br0: port 2(eth1) entering learning state
br0: port 1(vlan0) entering learning state
br0: port 2(eth1) entering forwarding state
br0: topology change detected, propagating
br0: port 1(vlan0) entering forwarding state
br0: topology change detected, propagating
vlan1: Setting MAC address to  01 38 06 09 01 38.
VLAN (vlan1):  Underlying device (eth0) has same MAC, not checking promiscious mode.
vlan1: add 01:00:5e:00:00:01 mcast address to master interface

lag***

一台2手的才几十块 没必要修了