|
|
Starting pid 4189, console /dev/console: '/bin/umount'
umount: none busy - remounted read-only
Sending SIGKILL to all processes.
Please stand by while rebooting the system.
Restarting system.
U-Boot 1.1.3 (Aug 25 2011 - 10:08:02)
Board: RT2880 DRAM: 32 MB
relocate_code Pointer at: 81f90000
config usb otg
twe0 set to <NULL>
toe0 set to <NULL>
flash_protect ON: from 0xBF000000 to 0xBF02C017
protect on 0
protect on 1
protect on 2
protect on 3
protect on 4
protect on 5
protect on 6
protect on 7
protect on 8
protect
flash_protect ON: from 0xBF02E000 to 0xBF02EFFF
protect on 9
*** Warning - bad CRC, using default environment
============================================
Ralink UBoot Version: 3.1
--------------------------------------------
ASIC 3052_MP1 (MAC to GigaMAC Mode)
DRAM COMPONENT: 256Mbits
DRAM BUS: 16BIT
Total memory: 32Mbytes
Date:Aug 25 2011 Time:10:08:02
============================================
icache: sets:256, ways:4, linesz:32 ,total:32768
dcache: sets:128, ways:4, linesz:32 ,total:16384
##### The CPU freq = 320 MHZ ####
SDRAM bus set to 16 bit
SDRAM size =32 Mbytes
***************DRIVER INFO*****************
DRIVER BUILD DATA: Aug 25 2011 at 10:08:06
DRIVER VERSION: R1.00
*******************************************
in func get_RunningFlag
Running flag value: 0xff
runging flag is 0
pid_addr 0x 3f9000
dbSign Addr: 0xbf3f9008
imgNum: 2
crc32_head_src result: 0x8c0cab14
img 0: start addr: 0x 50100, length: 0x d0450
crc32 result: 0x27fbdd47
checksum: 0x27fbdd47
check sum OK
img 1: start addr: 0x 121000, length: 0x 2d8000
crc32 result: 0xc0a74c4b
checksum: 0xc0a74c4b
check sum OK
mac address in flash is:00:0e:8f:96:4f:f2
Please choose the operation:
1: Load system code to SDRAM via TFTP.
2: Load system code then write to Flash via TFTP.
3: Boot system code via Flash (default).
4: Entr boot command line interface.
9: Load Boot Loader code then write to Flash via TFTP.
a: Sercomm Assign.
d: Sercomm Download.
You choosed 3
0
in func get_RunningFlag
Running flag va
runging flag is 0
3: System Boot system code via Flash.
## Booting image at bf050100 ...
Image Name: Linux Kernel Image
Created: 2012-05-14 12:59:44 UTC
System Control Status = 0x00400000
Image Type: MIPS Linux Kernel Image (lzma compressed)
Data Size: 853008 Bytes = 833 kB
Load Address: 80000000
Entry Point: 80299000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
No initrd
## Transferring control to Linux (at address 80299000) ...
## Giving linux memsize in MB,
Starting kernel ...
LINUX started...
THIS IS ASIC
Linux version 2.6.21 (root@arch_server) (gcc version 3.4.2) #114 Mon May 14 15:2
5:32 CST 2012
The CPU feqenuce set to 320 MHz
CPU revision is: 0001964c
Determined physical RAM map:
memory: 02000000 @ 00000000 (usable)
Built 1 zonelists. Total pages: 8128
Kernel command line: console=ttyS1,57600n8 root=/dev/mtdblock3
Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes.
Primary data cache 16kB, 4-way, linesize 32 bytes.
Synthesized TLB refill handler (20 instructions).
Synthesized TLB load handler fastpath (32 instructions).
Synthesized TLB store handler fastpath (32 instructions).
Synthesized TLB modify handler fastpath (31 instructions).
Cache parity protection disabled
cause = 800000, status = 1100ff00
PID hash table entries: 128 (order: 7, 512 bytes)
calculating r4koff... 00138800(1280000)
CPU frequency 320.00 MHz
Using 160.000 MHz high precision timer.
Console: colour dummy device 80x25
Dentry cache hash table entries: 4096
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Memory: 29500k/32768k available (2253k kernel code, 3268k reserved, 402k data, 1
28k init, 0k highmem)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
NET: Registered protocol family 2
Time: MIPS clocksource has been installed.
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP reno registered
squashfs: version 3.2-r2 (2007/01/15) Phillip Lougher
squashfs: LZMA suppport for slax.org by jro
io scheduler noop registered (default)
FLASH_API: MAN_ID=C2 DEV_ID=22CB SIZE=8MB
Ralink gpio driver initialized
Serial: 8250/16550 driver $Revision: 1.1.1.1 $ 4 ports, IRQ sharing disabled
serial8250: ttyS0 at I/O 0xb0000500 (irq = 37) is a 16550A
serial8250: ttyS1 at I/O 0xb0000c00 (irq = 12) is a 16550A
PPP generic driver version 2.4.2
PPP Deflate Compression module registered
PPP BSD Compression module registered
NET: Registered protocol family 24
ralink flash device: 0x800000 at 0xbf000000
Ralink SoC physically mapped flash: Found 1 x16 devices at 0x0 in 16-bit bank
Amd/Fujitsu Extended Query Table at 0x0040
number of CFI chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
calc zero number = 0
Creating 7 MTD partitions on "Ralink SoC physically mapped flash":
0x00000000-0x00030000 : "Bootloader"
0x00030000-0x00040000 : "Config_r"
0x00050000-0x00420000 : "Image_r"
0x00121000-0x00420000 : "FS"
mtd: partition "FS" doesn't start on an erase block boundary -- force read-only
0x00040000-0x00050000 : "Config_b"
0x00420000-0x007f0000 : "Image_b"
0x007f0000-0x00800000 : "Bootflag"
u32 classifier
Performance counters on
input device check on
IPv4 over IPv4 tunneling driver
GRE over IPv4 tunneling driver
ip_conntrack version 2.4 (256 buckets, 2048 max) - 236 bytes per conntrack
ip_conntrack_pptp version 3.1
ip_nat_pptp version 3.0 loaded
ip_tables: (C) 2000-2006 Netfilter Core Team, Type=Linux
ipt_random match loaded
TCP cubic registered
Initializing XFRM netlink socket
NET: Registered protocol family 1
NET: Registered protocol family 17
NET: Registered protocol family 15
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
VFS: Mounted root (squashfs filesystem) readonly.
Freeing unused kernel memory: 128k freed
init started: BusyBox v1.1.0 (2012.04.20-
init started: BusyBox v1.1.0 (2012.04.20-10:31+0000) multi-call binary
Starting pid 14, console /dAlgorithmics/MIPS FPU Emulator v1.5
ev/console: '/etc/rcS'
mount: Mounting none on /dev failed: No such device
GDMA1_MAC_ADRH -- : 0x00000000
GDMA1_MAC_ADRL -- : 0x00000000
Ralink APSoC Ethernet Driver Initilization. v1.60 64 rx/tx descriptors allocate
d, mtu = 1500!
GDMA1_MAC_ADRH -- : 0x0000b45d
GDMA1_MAC_ADRL -- : 0x000c4328
PROC INIT OK!
insmod: ipt_PNAT.ko: no module by that name found
insmod: ipt_mark.ko: no module by that name found
phy_tx_ring = 0x013d2000, tx_ring = 0xa13d2000, size: 16 bytes
phy_rx_ring = 0x013d3000, rx_ring = 0xa13d3000, size: 16 bytes
GDMA1_FWD_CFG = 10000
SIOCSIFADDR: No such device
interface ra0 does not exist!
eth2.1: dev_set_promiscuity(master, 1)
device eth2 entered promiscuous mode
device eth2.1 entered promiscuous mode
ap_name=printk action=start
ap_name=lan action=start
ap_name=wlan action=restart
interface wds3 does not exist!
interface wds2 does not exist!
interface wds1 does not exist!
interface wds0 does not exist!
SIOCGIFFLAGS: No such device
SIOCGIFFLAGS: No such device
SIOCGIFFLAGS: No such device
SIOCGIFFLAGS: No such device
interface ra0 does not exist!
SIOCGIFFLAGS: No such device
SIOCGIFFLAGS: No such device
rmmod: br_seperate: Success
interface ra1 does not exist!
SIOCGIFFLAGS: No such device
ra0 no private ioctls.
rmmod: rt2860v2_ap: Success
rmmod: rt2860v2_sta: Success
ap_name=syslogd action=start
killall: syslogd: no process killed
ap_name=httpd ac
ap_name=httpd ac
start dhcpd ......start dhcpd ... creat config...
create dhcpd config -- ok ...
ap_name=ntp action=start
[ERROR SL2CP] Get configuration information failed.
[ERROR SL2CP] Init sl2cp library failed.
ap_name=route action=start
ap_name=ripd action=start
ap_name=schedule action=create
ap_name=upnp action=start
killall: upnpd: no process killed
ap_name=sl2cp action=start
UPnP Initialized
Intialized UPnP
with fullurl=http://10.10.10.254:49152/gateway.xml
ipaddress=10.10.10.254 port=49152
web_dir_path=/usr/upnp/
desc_doc_url=http://10.10.10.254:49152
Specifying the webserver root directory -- /usr/upnp/
Registering the RootDevice
RootDevice Registered
Initializing State Table
fullurl http://10.10.10.254:49152/gateway.xml
Please press Enter to activate this console. |
|
简体中文
繁體中文
English
日本語
Deutsch
한국 사람
بالعربية
TÜRKÇE
português
คนไทย
IP卡
狗仔卡
发表于 2014-6-24 17:32
置顶卡
沉默卡
喧嚣卡
顶贴卡
显身卡
