|
本帖最后由 liutaozhang 于 2019-1-7 13:36 编辑
Boot and Recovery Environment for Embedded Devices
Copyright (C) 2018 HackPascal <hackpascal@gmail.com>
Build date 2018-12-29 [git-135bed9]
Version 1.1 (r1266)
DRAM: 512MB
Platform: MediaTek MT7621A ver 1, eco 3
Board: GeHua GHL-R-001
Clocks: CPU: 880MHz, DDR: 1066MHz, Bus: 293MHz, Ref: 40MHz
Flash: Macronix MX25L25635E (32MB) on mt7621-spi.0
rt2880-eth: MAC address from EEPROM is invalid, using default settings.
rt2880-eth: Using MAC address 00:0c:43:00:00:01
eth0: MediaTek MT7530 Gigabit switch
Network started on eth0, inet addr 192.168.1.1, netmask 255.255.255.0
Press any key to interrupt autoboot ... 0
Trying to boot firmware from 0x00050000 in flash bank 0 ...
Reading data into memory ...
U-Boot firmware image header detected.
Image Name: MIPS OpenWrt Linux-4.14.90
Data Size: 1934641 Bytes
Load Address: 80001000
Entry Point: 80001000
Uncompressing data (LZMA) ... done.
Flushing cache ... done.
Starting kernel at 0x80001000...
[ 0.000000] Linux version 4.14.90 (lhw@lhw-linux) (gcc version 7.4.0 (OpenWrt GCC 7.4.0 r1138-6408dc1b)) #0 SMP Fri Jan 4 06:17:24 2019
[ 0.000000] SoC Type: MediaTek MT7621 ver:1 eco:3
[ 0.000000] bootconsole [early0] enabled
[ 0.000000] CPU0 revision is: 0001992f (MIPS 1004Kc)
[ 0.000000] MIPS: machine is GeHua GHL-R-001
[ 0.000000] Determined physical RAM map:
[ 0.000000] memory: 1c000000 @ 00000000 (usable)
[ 0.000000] memory: 04000000 @ 20000000 (usable)
[ 0.000000] Initrd not found or empty - disabling initrd
[ 0.000000] VPE topology {2,2} total 4
[ 0.000000] Primary instruction cache 32kB, VIPT, 4-way, linesize 32 bytes.
[ 0.000000] Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes
[ 0.000000] MIPS secondary cache 256kB, 8-way, linesize 32 bytes.
[ 0.000000] Zone ranges:
[ 0.000000] Normal [mem 0x0000000000000000-0x000000000fffffff]
[ 0.000000] HighMem [mem 0x0000000010000000-0x0000000023ffffff]
[ 0.000000] Movable zone start for each node
[ 0.000000] Early memory node ranges
[ 0.000000] node 0: [mem 0x0000000000000000-0x000000001bffffff]
[ 0.000000] node 0: [mem 0x0000000020000000-0x0000000023ffffff]
[ 0.000000] Initmem setup node 0 [mem 0x0000000000000000-0x0000000023ffffff]
[ 0.000000] random: get_random_bytes called from start_kernel+0x90/0x4a4 with crng_init=0
[ 0.000000] percpu: Embedded 14 pages/cpu @81490000 s26704 r8192 d22448 u57344
[ 0.000000] Built 1 zonelists, mobility grouping on. Total pages: 130560
[ 0.000000] Kernel command line: console=ttyS0,57600 rootfstype=squashfs,jffs2
[ 0.000000] PID hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.000000] Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
[ 0.000000] Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
[ 0.000000] Writing ErrCtl register=0003682b
[ 0.000000] Readback ErrCtl register=0003682b
[ 0.000000] Memory: 512820K/524288K available (4570K kernel code, 233K rwdata, 1012K rodata, 252K init, 248K bss, 11468K reserved, 0K cma-reserved, 262144K highmem)
[ 0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=4, Nodes=1
[ 0.000000] Hierarchical RCU implementation.
[ 0.000000] NR_IRQS: 256
[ 0.000000] CPU Clock: 880MHz
[ 0.000000] clocksource: GIC: mask: 0xffffffffffffffff max_cycles: 0xcaf478abb4, max_idle_ns: 440795247997 ns
[ 0.000000] clocksource: MIPS: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 4343773742 ns
[ 0.000009] sched_clock: 32 bits at 440MHz, resolution 2ns, wraps every 4880645118ns
[ 0.015513] Calibrating delay loop... 586.13 BogoMIPS (lpj=2930688)
[ 0.087832] pid_max: default: 32768 minimum: 301
[ 0.097155] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.110176] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.126040] Hierarchical SRCU implementation.
[ 0.135536] smp: Bringing up secondary CPUs ...
[ 9.026041] Primary instruction cache 32kB, VIPT, 4-way, linesize 32 bytes.
[ 9.026051] Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes
[ 9.026063] MIPS secondary cache 256kB, 8-way, linesize 32 bytes.
[ 9.026209] CPU1 revision is: 0001992f (MIPS 1004Kc)
[ 0.204887] Synchronize counters for CPU 1: done.
[ 9.327824] Primary instruction cache 32kB, VIPT, 4-way, linesize 32 bytes.
[ 9.327834] Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes
[ 9.327843] MIPS secondary cache 256kB, 8-way, linesize 32 bytes.
[ 9.327915] CPU2 revision is: 0001992f (MIPS 1004Kc)
[ 0.325658] Synchronize counters for CPU 2: done.
[ 3.081220] Primary instruction cache 32kB, VIPT, 4-way, linesize 32 bytes.
[ 3.081227] Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes
[ 3.081236] MIPS secondary cache 256kB, 8-way, linesize 32 bytes.
[ 3.081334] CPU3 revision is: 0001992f (MIPS 1004Kc)
[ 0.445220] Synchronize counters for CPU 3: done.
[ 0.504823] smp: Brought up 1 node, 4 CPUs
[ 0.516725] clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 19112604462750000 ns
[ 0.536199] futex hash table entries: 1024 (order: 3, 32768 bytes)
[ 0.548659] pinctrl core: initialized pinctrl subsystem
[ 0.560550] NET: Registered protocol family 16
[ 0.580596] pull PCIe RST: RALINK_RSTCTRL = 0
请不要胡乱输入以及粘贴、复制等方式灌水
请尊重作者、并共同维护网站的正常阅读,否则账户将会被限制发帖、回帖,并且积分可能会被清零,站内短信以及阅读权限等都会受到影响,谢谢。
具体限制方式:https://www.right.com.cn/forum/thread-8307840-1-1.html
|
|