麻烦大家看看问题，这是tll启动内容，问题在哪，一直不能启动

liutaozhang

Boot and Recovery Environment for Embedded Devices
Copyright (C) 2018 HackPascal <hackpascal@gmail.com>
Build date 2018-12-29 [git-135bed9]
Version 1.1 (r1266)

DRAM: 512MB
Platform: MediaTek MT7621A ver 1, eco 3
Board: GeHua GHL-R-001
Clocks: CPU: 880MHz, DDR: 1066MHz, Bus: 293MHz, Ref: 40MHz
Flash: Macronix MX25L25635E (32MB) on mt7621-spi.0
rt2880-eth: MAC address from EEPROM is invalid, using default settings.
rt2880-eth: Using MAC address 00:0c:43:00:00:01
eth0: MediaTek MT7530 Gigabit switch

Network started on eth0, inet addr 192.168.1.1, netmask 255.255.255.0

Press any key to interrupt autoboot ... 0   

Trying to boot firmware from 0x00050000 in flash bank 0 ...
Reading data into memory ...
U-Boot firmware image header detected.
    Image Name:   MIPS OpenWrt Linux-4.14.90
    Data Size:    1934641 Bytes
    Load Address: 80001000
    Entry Point:  80001000
Uncompressing data (LZMA) ... done.
Flushing cache ... done.

Starting kernel at 0x80001000...

[    0.000000] Linux version 4.14.90 (lhw@lhw-linux) (gcc version 7.4.0 (OpenWrt GCC 7.4.0 r1138-6408dc1b)) #0 SMP Fri Jan 4 06:17:24 2019
[    0.000000] SoC Type: MediaTek MT7621 ver:1 eco:3
[    0.000000] bootconsole [early0] enabled
[    0.000000] CPU0 revision is: 0001992f (MIPS 1004Kc)
[    0.000000] MIPS: machine is GeHua GHL-R-001
[    0.000000] Determined physical RAM map:
[    0.000000]  memory: 1c000000 @ 00000000 (usable)
[    0.000000]  memory: 04000000 @ 20000000 (usable)
[    0.000000] Initrd not found or empty - disabling initrd
[    0.000000] VPE topology {2,2} total 4
[    0.000000] Primary instruction cache 32kB, VIPT, 4-way, linesize 32 bytes.
[    0.000000] Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes
[    0.000000] MIPS secondary cache 256kB, 8-way, linesize 32 bytes.
[    0.000000] Zone ranges:
[    0.000000]   Normal   [mem 0x0000000000000000-0x000000000fffffff]
[    0.000000]   HighMem  [mem 0x0000000010000000-0x0000000023ffffff]
[    0.000000] Movable zone start for each node
[    0.000000] Early memory node ranges
[    0.000000]   node   0: [mem 0x0000000000000000-0x000000001bffffff]
[    0.000000]   node   0: [mem 0x0000000020000000-0x0000000023ffffff]
[    0.000000] Initmem setup node 0 [mem 0x0000000000000000-0x0000000023ffffff]
[    0.000000] random: get_random_bytes called from start_kernel+0x90/0x4a4 with crng_init=0
[    0.000000] percpu: Embedded 14 pages/cpu @81490000 s26704 r8192 d22448 u57344
[    0.000000] Built 1 zonelists, mobility grouping on.  Total pages: 130560
[    0.000000] Kernel command line: console=ttyS0,57600 rootfstype=squashfs,jffs2
[    0.000000] PID hash table entries: 1024 (order: 0, 4096 bytes)
[    0.000000] Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
[    0.000000] Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
[    0.000000] Writing ErrCtl register=0003682b
[    0.000000] Readback ErrCtl register=0003682b
[    0.000000] Memory: 512820K/524288K available (4570K kernel code, 233K rwdata, 1012K rodata, 252K init, 248K bss, 11468K reserved, 0K cma-reserved, 262144K highmem)
[    0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=4, Nodes=1
[    0.000000] Hierarchical RCU implementation.
[    0.000000] NR_IRQS: 256
[    0.000000] CPU Clock: 880MHz
[    0.000000] clocksource: GIC: mask: 0xffffffffffffffff max_cycles: 0xcaf478abb4, max_idle_ns: 440795247997 ns
[    0.000000] clocksource: MIPS: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 4343773742 ns
[    0.000009] sched_clock: 32 bits at 440MHz, resolution 2ns, wraps every 4880645118ns
[    0.015513] Calibrating delay loop... 586.13 BogoMIPS (lpj=2930688)
[    0.087832] pid_max: default: 32768 minimum: 301
[    0.097155] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes)
[    0.110176] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes)
[    0.126040] Hierarchical SRCU implementation.
[    0.135536] smp: Bringing up secondary CPUs ...
[    9.026041] Primary instruction cache 32kB, VIPT, 4-way, linesize 32 bytes.
[    9.026051] Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes
[    9.026063] MIPS secondary cache 256kB, 8-way, linesize 32 bytes.
[    9.026209] CPU1 revision is: 0001992f (MIPS 1004Kc)
[    0.204887] Synchronize counters for CPU 1: done.
[    9.327824] Primary instruction cache 32kB, VIPT, 4-way, linesize 32 bytes.
[    9.327834] Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes
[    9.327843] MIPS secondary cache 256kB, 8-way, linesize 32 bytes.
[    9.327915] CPU2 revision is: 0001992f (MIPS 1004Kc)
[    0.325658] Synchronize counters for CPU 2: done.
[    3.081220] Primary instruction cache 32kB, VIPT, 4-way, linesize 32 bytes.
[    3.081227] Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes
[    3.081236] MIPS secondary cache 256kB, 8-way, linesize 32 bytes.
[    3.081334] CPU3 revision is: 0001992f (MIPS 1004Kc)
[    0.445220] Synchronize counters for CPU 3: done.
[    0.504823] smp: Brought up 1 node, 4 CPUs
[    0.516725] clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 19112604462750000 ns
[    0.536199] futex hash table entries: 1024 (order: 3, 32768 bytes)
[    0.548659] pinctrl core: initialized pinctrl subsystem
[    0.560550] NET: Registered protocol family 16
[    0.580596] pull PCIe RST: RALINK_RSTCTRL = 0

请不要胡乱输入以及粘贴、复制等方式灌水

请尊重作者、并共同维护网站的正常阅读，否则账户将会被限制发帖、回帖，并且积分可能会被清零，站内短信以及阅读权限等都会受到影响，谢谢。 具体限制方式：https://www.right.com.cn/forum/thread-8307840-1-1.html

liutaozhang

到这就不启动了

LGA1150

断电 10s 以上，再通电

liutaozhang

断电还是照旧

gubinhao

看样子启动到一半就死了，你可以恢复系统 看看  或者是重刷固件