|
以下是刷机代码
U-Boot 1.1.4 (Dec 4 2012 - 15:44:21)
AP121 (ar9330) U-boot
DRAM: 32 MB
led turning on for 1s...
id read 0x100000ff
flash size 4194304, sector count = 64
Flash: 4 MB
Using default environment
In: serial
Out: serial
Err: serial
Net: ag7240_enet_initialize...
No valid address in Flash. Using fixed address
No valid address in Flash. Using fixed address
: cfg1 0x5 cfg2 0x7114
eth0: 00:03:7f:09:0b:ad
ag7240_phy_setup
eth0 up
: cfg1 0xf cfg2 0x7214
eth1: 00:03:7f:09:0b:ad
athrs26_reg_init_lan
ATHRS26: resetting s26
ATHRS26: s26 reset done
ag7240_phy_setup
eth1 up
eth0, eth1
Autobooting in 1 seconds
## Booting image at 9f020000 ...
Uncompressing Kernel Image ... OK
Starting kernel ...
[ 0.000000] Linux version 3.8.13 (fnord@tschunk) (gcc version 4.6.4 (OpenWrt/Linaro GCC 4.6-2012.12 r36817) ) #1 Mon Jun 3 03:42:55 UTC 2013
[ 0.000000] bootconsole [early0] enabled
[ 0.000000] CPU revision is: 00019374 (MIPS 24Kc)
[ 0.000000] SoC: Atheros AR9330 rev 1
[ 0.000000] Clocks: CPU:400.000MHz, DDR:400.000MHz, AHB:200.000MHz, Ref:25.000MHz
[ 0.000000] Determined physical RAM map:
[ 0.000000] memory: 02000000 @ 00000000 (usable)
[ 0.000000] Initrd not found or empty - disabling initrd
[ 0.000000] Zone ranges:
[ 0.000000] Normal [mem 0x00000000-0x01ffffff]
[ 0.000000] Movable zone start for each node
[ 0.000000] Early memory node ranges
[ 0.000000] node 0: [mem 0x00000000-0x01ffffff]
[ 0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
[ 0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
[ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128
[ 0.000000] Kernel command line: board=TL-MR11U console=ttyATH0,115200 rootfstype=squashfs,jffs2 noinitrd
[ 0.000000] PID hash table entries: 128 (order: -3, 512 bytes)
[ 0.000000] Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
[ 0.000000] Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
[ 0.000000] __ex_table already sorted, skipping sort
[ 0.000000] Writing ErrCtl register=00000000
[ 0.000000] Readback ErrCtl register=00000000
[ 0.000000] Memory: 28720k/32768k available (2306k kernel code, 4048k reserved, 606k data, 220k init, 0k highmem)
[ 0.000000] SLUB: Genslabs=9, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
[ 0.000000] NR_IRQS:51
[ 0.000000] Calibrating delay loop... 265.42 BogoMIPS (lpj=1327104)
[ 0.080000] pid_max: default: 32768 minimum: 301
[ 0.080000] Mount-cache hash table entries: 512
[ 0.090000] NET: Registered protocol family 16
[ 0.090000] MIPS: machine is TP-LINK TL-MR11U
[ 0.350000] bio: create slab <bio-0> at 0
[ 0.350000] Switching to clocksource MIPS
[ 0.360000] NET: Registered protocol family 2
[ 0.360000] TCP established hash table entries: 512 (order: 0, 4096 bytes)
[ 0.370000] TCP bind hash table entries: 512 (order: -1, 2048 bytes)
[ 0.370000] TCP: Hash tables configured (established 512 bind 512)
[ 0.380000] TCP: reno registered
[ 0.380000] UDP hash table entries: 256 (order: 0, 4096 bytes)
[ 0.390000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[ 0.400000] NET: Registered protocol family 1
[ 0.420000] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[ 0.420000] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
[ 0.430000] msgmni has been set to 56
[ 0.440000] Block layer SCSI generic (bsg) driver version 0.4 loaded (major 253)
[ 0.440000] io scheduler noop registered
[ 0.450000] io scheduler deadline registered (default)
[ 0.450000] Serial: 8250/16550 driver, 16 ports, IRQ sharing enabled
[ 0.460000] ar933x-uart: ttyATH0 at MMIO 0x18020000 (irq = 11) is a AR933X UART
[ 0.470000] console [ttyATH0] enabled, bootconsole disabled
[ 0.470000] console [ttyATH0] enabled, bootconsole disabled
[ 0.480000] ath79-spi ath79-spi: master is unqueued, this is deprecated
[ 0.490000] m25p80 spi0.0: found s25sl032p, expected m25p80
[ 0.490000] m25p80 spi0.0: s25sl032p (4096 Kbytes)
[ 0.500000] 5 tp-link partitions found on MTD device spi0.0
[ 0.500000] Creating 5 MTD partitions on "spi0.0":
[ 0.510000] 0x000000000000-0x000000020000 : "u-boot"
[ 0.520000] 0x000000020000-0x0000001231e0 : "kernel"
[ 0.520000] mtd: partition "kernel" must either start or end on erase block boundary or be smaller than an erase block -- forcing read-only
[ 0.530000] 0x0000001231e0-0x0000003f0000 : "rootfs"
[ 0.540000] mtd: partition "rootfs" must either start or end on erase block boundary or be smaller than an erase block -- forcing read-only
[ 0.550000] mtd: partition "rootfs" set to be root filesystem
[ 0.560000] mtd: partition "rootfs_data" created automatically, ofs=2E0000, len=110000
[ 0.560000] 0x0000002e0000-0x0000003f0000 : "rootfs_data"
[ 0.570000] 0x0000003f0000-0x000000400000 : "art"
[ 0.580000] 0x000000020000-0x0000003f0000 : "firmware"
[ 0.600000] libphy: ag71xx_mdio: probed
[ 0.600000] eth0: Atheros AG71xx at 0xb9000000, irq 4, mode:MII
[ 1.150000] ag71xx ag71xx.0 eth0: connected to PHY at ag71xx-mdio.1:04 [uid=004dd041, driver=Generic PHY]
[ 1.160000] TCP: cubic registered
[ 1.170000] NET: Registered protocol family 17
[ 1.170000] Bridge firewalling registered
[ 1.170000] 8021q: 802.1Q VLAN Support v1.8
33222222[ 1.190000] VFS: Mounted root (squashfs filesystem) readonly on device 31:2.
[ 1.190000] Freeing unused kernel memory: 220k freed
2f
f
- preinit -
fPress the [f] key and hit [enter] to enter failsafe mode
- failsafe -
BusyBox v1.19.4 (2013-06-02 20:36:52 UTC) built-in shell (ash)
Enter 'help' for a list of built-in commands.
_______ ________ __
| |.-----.-----.-----.| | | |.----.| |_
| - || _ | -__| || | | || _|| _|
|_______|| __|_____|__|__||________||__| |____|
|__| W I R E L E S S F R E E D O M
-----------------------------------------------------
BARRIER BREAKER (Bleeding Edge, r36817)
-----------------------------------------------------
* 1/2 oz Galliano Pour all ingredients into
* 4 oz cold Coffee an irish coffee mug filled
* 1 1/2 oz Dark Rum with crushed ice. Stir.
* 2 tsp. Creme de Cacao
-----------------------------------------------------
root@(none):/# |
|