rtorrent终于可以正常运行了，不过为什么速度一直是0K！

pdckxd

经过这两天的测试，终于让rtorrent运行出来了，可是我选了3个peer和seed都很多的种子为什么死活不下载（速度一直在1K左右徘徊）

WL-HDD BT机（未开路由功能，单纯的一个无线HDD设备，使用oleg wlhdd1.9.2.7-9固件，硬盘挂的是日立的120G）

路由器是LINKSYS WRT54GS V1（固件是Tomato Firmware v1.17.1385），设置过port forwarding 确定.rtorrent.rc中的port range和54GS上的映射端口范围一致（51777-51780）

使用enhanced-ctorrent下载同一个种子在10秒种之内速度上到150KB/S

使用rtorrent下载就一直无动于衷（再54GS上为WL-HDD开启DMZ后还是这个症状）

rtorrent版本是0.8001

pdckxd

顶一下

pdckxd

连接数超级多，就是不下载

配置：
# This is an example resource file for rTorrent. Copy to
# ~/.rtorrent.rc and enable/modify the options as needed. Remember to
# uncomment the options you wish to enable.

# Minumum amount of peers to connect per torrent, if available.
min_peers = 20

# Minumum amount of peers to connect per torrent.
max_peers = 250

# Same as above but for seeding completed torrents (-1 = same as downloading)
min_peers_seed = 10
max_peers_seed = 50

# Maximum number of simultanious uploads per torrent.
max_uploads = 15

# Global download rate in KiB. "0" for unlimited.
download_rate = 0

# Global upload rate in KiB. "0" for unlimited.
upload_rate = 100

# Default directory to save downloaded files. Note it doesn't support
# space yet.
directory = /opt/share/downloads

# Watch a directory for new torrents, and stop those that have been deleted.
schedule = watch_directory,5,5,load_start=/opt/share/torrent/dl/*.torrent
#schedule = untied_directory,5,5,stop_untied=

# Close torrents when diskspace is low.
#schedule = low_diskspace,5,60,close_low_diskspace=100M

# Default session directory. Make sure you don't run multiple instance
# of rtorrent using the same session directory. Perhaps using a
# relative path?
session = /opt/share/torrent/session

# The ip address reported to the tracker.
#ip = rakshasa

# The ip address the listening socket and outgoing connections is
# bound to.
#bind = rakshasa

# Port range to use for listening.
port_range = 51777-51780

# Start opening ports at a random position within the port range.
#port_random = no

# Check hash for finished torrents. Might be usefull until the bug is
# fixed that causes lack of diskspace not to be properly reported.
#check_hash = no

# Set whetever the client should try to connect to UDP trackers.
#use_udp_trackers = yes

# Alternative calls to bind and ip that should handle dynamic ip's.
#schedule = ip_tick,0,1800,ip=rakshasa
#schedule = bind_tick,0,1800,bind=rakshasa

#
# Do not modify the following parameters unless you know what you're doing.
#

# Hash read-ahead controls how many MB to request the kernel to read
# ahead. If the value is too low the disk may not be fully utilized,
# while if too high the kernel might not be able to keep the read
# pages in memory thus end up trashing.
#hash_read_ahead = 10

# Interval between attempts to check the hash, in milliseconds.
#hash_interval = 100

# Number of attempts to check the hash while using the mincore status,
# before forcing. Overworked systems might need lower values to get a
# decent hash checking rate.
#hash_max_tries = 10

# Max number of files to keep open simultaniously.
#max_open_files = 128

# Number of sockets to simultaneously keep open.
#max_open_sockets = <no default>


# Example of scheduling commands: Switch between two ip's every 5
# seconds.
#schedule = "ip_tick1,5,10,ip=torretta"
#schedule = "ip_tick2,10,10,ip=lampedusa"

# Remove a scheduled event.
#schedule_remove = "ip_tick1"

# Stop torrents when reaching upload ratio in percent,
# when also reaching total upload in bytes, or when
# reaching final upload ratio in percent.
# example: stop at ratio 2.0 with at least 200 MB uploaded, or else ratio 20.0
#schedule = ratio,60,60,"stop_on_ratio=200,200M,2000"
schedule = ratio,30,60,stop_on_ratio=200


# Encryption options, set to none (default) or any combination of the following:
# allow_incoming, try_outgoing, require, require_RC4, enable_retry, prefer_plaintext
#
# The example value allows incoming encrypted connections, starts unencrypted
# outgoing connections but retries with encryption if they fail, preferring
# plaintext to RC4 encryption after the encrypted handshake
#
encryption = allow_incoming,enable_retry,prefer_plaintext

# Enable DHT support for trackerless torrents or when all trackers are down.
# May be set to "disable" (completely disable DHT), "off" (do not start DHT),
# "auto" (start and stop DHT as needed), or "on" (start DHT immediately).
# The default is "off". For DHT to work, a session directory must be defined.
#
dht = auto

# UDP port to use for DHT.
#
dht_port = 6881

# Enable peer exchange (for torrents not marked private)
#
peer_exchange = yes

#
# Do not modify the following parameters unless you know what you're doing.
#

端口映射：
On        Proto        Src Address        Ext Ports        Int Port        Int Address        Description
On        Both                2706        2706        192.168.1.126        enhanced-ctorrent
On        Both                51779        51779        192.168.1.126        rTorrent
On        Both                51778        51778        192.168.1.126        rTorrent
On        Both                51777        51777        192.168.1.126        rTorrent
On        Both                51780        51780        192.168.1.126        rTorrent

pdckxd

一些图片

pdckxd

Peers 150+
速度一点都幕友，奇怪到死啊

pdckxd

出现大量的network error、network unreachable、handshake failed

chapiom

我把防火墙关了，速度飞快。。。。。。

pdckxd

我死活没有数据传输，挂了1天1KB都没有下载下来

pdckxd

没办法解决了，放弃这个奇怪的rtorrent了

tonger

参照这两个端口号，分别在路由器上设置映射就可以了

port_range = 51777-51780    设置映射端口段：51777-51780


dht_port = 6881                   设置映射端口号：6881

pdckxd

我怀疑应该是ISP限制了，不过连接PEER数目都在150+就是一个PEER都不给我速度，种子完成度一直停留在0%位置，实在是没有办法了

tonger

要是ISP限制的话别的软件怎么能下？？？
peer多不代表一定能下，觉得还是端口映射问题，不如帖你的端口映射图....

另外，你配置完rtorrent.conf文件后有没有打过这两条名令？

mkdir /opt/root

cp /opt/etc/rtorrent.conf /opt/root/.rtorrent.rc

pdckxd

那个命令我打过了，设置文件没有问题

tonger

映射端口段51777-51780就行了，没必要一个个映射.......192.168.1.126是硬盘地址没错吧

pdckxd

也没错