问题: 我的板子没有reset, 刷了hackpascal的u-boot
1. 今天折腾TTL刷机时, 偶然看到了httpd命令, 当时想莫非就是进入web页面的空间通道?
ar7240> ?
? - alias for 'help'
autoboot- auto detect image type and boot
bootm - boot application image from memory
cp - memory copy
crc32 - checksum calculation
erase - erase FLASH memory
flinfo - print FLASH memory information
flread - read FLASH memory into RAM
getlang - get current web failsafe lang
help - print online help
httpd - start web failsafe HTTP server
md - memory display
mm - memory modify (auto-incrementing)
mw - memory write (fill)
netcon - start network console via UDP
nm - memory modify (constant address)
pll - Set to change CPU/AHB/DDR speeds and save into flash
printenv- print environment variables
progmac - Set ethernet MAC addresses
progpin - Set WPS/QSS PIN code
reset - Perform RESET of the CPU
sercon - switch to serial console
setenv - set environment variables
setlang - set current web failsafe lang
tftpboot- boot image via network using TFTP protocol
version - print monitor version
2. 真心不想改电脑IP, 用setenv命令进行设置
#设置路由器的IP
ar7240> setenv ipaddr 192.168.8.99
#设置服务器IP, 改成自己的电脑IP即可
ar7240> setenv serverip 192.168.8.9
3. 启动httpd命令, 看到了些信息
ar7240> httpd
eth1 link down
dup 1 speed 100
Web console started at 192.168.8.99
GET / HTTP/1.1
GET /style.css HTTP/1.1
GET /favicon.ico HTTP/1.1
4. 网页端登录 http://192.168.8.99/, 一切都是那么的亲切了, 然后你们都懂的
请不要胡乱输入以及粘贴、复制等方式灌水
请尊重作者、并共同维护网站的正常阅读,否则账户将会被限制发帖、回帖,并且积分可能会被清零,站内短信以及阅读权限等都会受到影响,谢谢。
具体限制方式:https://www.right.com.cn/forum/thread-8307840-1-1.html
|