|
楼主 |
发表于 2016-2-26 12:59
|
显示全部楼层
Booting...
********************************************************************************
*
* chip__no chip__id mfr___id dev___id cap___id size_sft dev_size chipSize
* 0000000h 01c7015h 000001ch 0000070h 0000015h 0000001h 0000016h 0400000h
* blk_size blk__cnt sec_size sec__cnt pageSize page_cnt chip_clk chipName
* 0010000h 0000040h 0001000h 0000400h 0000100h 0000010h 0000027h UNKNOWN
*
********************************************************************************
Reboot Result from Watchdog Timeout!
---RealTek(RTL8196E)at 2014.01.20-19:29+0800 v0.3 [16bit](380MHz)
no sys signature at d00010000!
no sys signature at d00020000!
Jump to image start=0x80500000...
decompressing kernel:
Uncompressing... done, booting the kernel.
done decompressing kernel.
start address: 0x800004c4
0x1c7015 UNKNOWN
Creating Init Thread...
alloc apmib hw ok!
alloc apmib ds ok!
alloc apmib cs ok!
asdfaaaaaa
aaaa:1
-------------netcore_button_type=0
aaaa:l
zzzzzzzzzzzzzzxxxxxxx-------------------wan:l
aaaacccc:l
zzzzzzzzzzzzzxxxxxxxxz-------------------wan_led:l
module:NW938
main_loop:482 ***************** netcore(%s)CN-V2.0.6357, 2015.01.15 18:56.
netcore(%s)CN-V2.0.6357, 2015.01.15 18:56.
LanPortCount:0
kuaiwan ad:1
Loading Run Parametersa...
ParamInit malloc
flashenhanced/src/ver1/flash_up_function_read.cpp:31 pFlashAddress:10000,pRamAd
dress:8058aa68,Length:54
flashenhanced/src/ver1/flash_up_function_read.cpp:31 pFlashAddress:10014,pRamAd
dress:8057a9d0,Length:1ff5
flashenhanced/src/ver1/flash_up_function_read.cpp:31 pFlashAddress:10000,pRamAd
dress:8058ab04,Length:54
flashenhanced/src/ver1/flash_up_function_read.cpp:31 pFlashAddress:18000,pRamAd
dress:8058aa68,Length:54
flashenhanced/src/ver1/flash_up_function_read.cpp:31 pFlashAddress:10000,pRamAd
dress:806b63b8,Length:2009
ParamFinal free
ParamInit malloc
flashenhanced/src/ver1/flash_up_function_read.cpp:31 pFlashAddress:10000,pRamAd
dress:806b73c8,Length:2009
------------ wl load----------------
ParamFinal free
prep_ifaces:ifaces_found:0, dev->irq1:15
prep_ifaces:ifaces_found:1, dev->irq1:9
prep_ifaces:ifaces_found:2, dev->irq1:0
prep_ifaces:ifaces_found:3, dev->irq1:0
prep_ifaces:ifaces_found:4, dev->irq1:0
all pkt ________________________ 241
revcq init
if_start 294 iface:0
if_start 294 iface:1
val32 = 7c
len = 680962
para size 64KB
flashenhanced/src/ver1/flash_up_function_read.cpp:31 pFlashAddress:10000,pRamAd
dress:8076b528,Length:2009
br_update***eth0****eth0
br_update***wlan0****wlan0
br_update***wlan0-wds0****wlan0-wds0
br_update***wlan0-wds1****wlan0-wds1
br_update***wlan0-wds2****wlan0-wds2
br_update***wlan0-wds3****wlan0-wds3
!!!!!!!!!!!!!!!!!!!!!!!!!!!!1 wireless_start !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!1
wl_wps_pageshow=0
---------- 99:08:10:78:A2:BC:5C
Encrypt:NONE AuthMode:OPEN
DISABLE=0
Mode=0
SSID=Netcore_A2BC5C
Band=11
Channel=6
auth:1 enc:1
Rate=0
TxPower=0
WdsMode=0
wds encrypt:NONE 0
WSC ENABLE:0
WSC CONFIGURED:0
WSC ROUTER PIN:158732
wireless restart.
netcore(%s)CN-V2.0.6357, 2015.01.15 18:56.
LAN_IP=192.168.1.1,unusemem=4096KB
Realtek GPIO init
apmib_init() ok!
--------------------------------------netcore_wan_port-l:l
set port:0:status:3
set port:1:status:3
set port:2:status:3
set port:3:status:3
set port:4:status:3
cyg waiting.......................................... |
|