求助：哦耶0001刷极壹s后无法进入uboot

qingf***

如题，用ttl线无法中断

U-Boot 1.1.3 (Mar 11 2016 - 13:00:13)
Board: Ralink APSoC DRAM:  128 MB
enable ephy clock...done. rf reg 29 = 5
SSC disabled.
spi device id: ef 40 18 0 0 (40180000)
find flash: w25q128
*** Warning - bad CRC, using default environment
============================================
ASIC 7620_MP (Port5<->None)
DRAM component: 1024 Mbits DDR, width 16
DRAM bus: 16 bit
Flash component: SPI Flash
Date:Mar 11 2016  Time:13:00:13
============================================
0
## Booting image at bc050000 ...
   Image Name:   HC5661
   Image Type:   MIPS Linux Kernel Image (lzma compressed)
   Data Size:    1424355 Bytes =  1.4 MB
   Load Address: 80000000
   Entry Point:  80000000
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK
Starting kernel ...
[    0.000000] Initializing cgroup subsys cpuset
[    0.000000] Initializing cgroup subsys cpu
[    0.000000] Linux version 3.3.8 (build@DEV-9-1-243) (gcc version 4.6.4 20121210 (prerelease) (Linaro GCC 4.6-2012.12) ) #1 Fri Mar 11 13:46:12 CST 2016
[    0.000000]
[    0.000000]  The CPU feqenuce set to 580 MHz
[    0.000000]  Disable DDR auto self refresh
[    0.000000]
[    0.000000]  MIPS CPU sleep mode enabled.
[    0.000000]  PCIE: bypass PCIe DLL.
[    0.000000]  PCIE: Elastic buffer control: Addr:0x68 -> 0xB4
[    0.000000]  disable all power about PCIe
[    0.000000] CPU revision is: 00019650 (MIPS 24KEc)
[    0.000000] Determined physical RAM map:
[    0.000000]  memory: 08000000 @ 00000000 (usable)
[    0.000000] Initrd not found or empty - disabling initrd
[    0.000000] Zone PFN ranges:
[    0.000000]   Normal   0x00000000 -> 0x00008000
[    0.000000] Movable zone start PFN for each node
[    0.000000] Early memory PFN ranges
[    0.000000]     0: 0x00000000 -> 0x00008000
[    0.000000] Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 32512
[    0.000000] Kernel command line:  board=HC5661 console=ttyS1,115200 rootfstype=squashfs,jffs2
[    0.000000] PID hash table entries: 512 (order: -1, 2048 bytes)
[    0.000000] Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
[    0.000000] Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
[    0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
[    0.000000] Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes
[    0.000000] Writing ErrCtl register=0007ff99
[    0.000000] Readback ErrCtl register=0007ff99
[    0.000000] allocated 262144 bytes of page_cgroup
[    0.000000] please try 'cgroup_disable=memory' option if you don't want memory cgroups
[    0.000000] Memory: 125632k/131072k available (2757k kernel code, 5440k reserved, 612k data, 372k init, 0k highmem)
[    0.000000] SLUB: Genslabs=9, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
[    0.000000] NR_IRQS:128
[    0.000000] MTK/Ralink System Tick Counter init... cd:80337be0, m:214748, s:32
[    0.000000] console [ttyS1] enabled
[    0.010000] Calibrating delay loop... 385.84 BogoMIPS (lpj=1929216)
[    0.070000] pid_max: default: 32768 minimum: 301
[    0.070000] Mount-cache hash table entries: 512
[    0.070000] Initializing cgroup subsys memory
[    0.080000] Initializing cgroup subsys net_cls
[    0.080000] Initializing cgroup subsys blkio
[    0.090000] NET: Registered protocol family 16
[    0.090000] MIPS: machine is Hiwifi Wireless HC5661 Board
[    0.100000] gpiochip_add: registered GPIOs 0 to 23 on device: MT7620-GPIO0
[    0.100000] gpiochip_add: registered GPIOs 24 to 39 on device: MT7620-GPIO1
[    0.110000] gpiochip_add: registered GPIOs 40 to 71 on device: MT7620-GPIO2
[    0.110000] gpiochip_add: registered GPIOs 72 to 72 on device: MT7620-GPIO3
[    0.120000] RALINK_GPIOMODE = 201d
[    0.120000] RALINK_GPIOMODE = 201d
[    0.120000] PPLL_CFG1=0xe8c000
[    0.130000] MT7620 PPLL lock
[    0.130000] PPLL_DRV =0x80080504
[    0.130000] start PCIe register access
[    0.630000] RALINK_RSTCTRL = 2400000
[    0.640000] RALINK_CLKCFG1 = 75afffc0
[    0.640000]
[    0.640000] *************** MT7620 PCIe RC mode *************
[    1.140000] PCIE0 no card, disable it(RST&CLK)
[    1.150000] PCIE0 enabled
[    1.150000] Port 0 N_FTS = ffffffff
[    1.150000] init_rt2880pci done
[    1.160000] bio: create slab <bio-0> at 0
[    1.170000] PCI host bridge to bus 0000:00
[    1.170000] pci_bus 0000:00: root bus resource [mem 0x20000000-0x2fffffff]
[    1.180000] pci_bus 0000:00: root bus resource [io  0x10160000-0x1016ffff]
[    1.180000] Switching to clocksource Ralink external timer
[    1.190000] NET: Registered protocol family 2
[    1.190000] IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
[    1.200000] TCP established hash table entries: 4096 (order: 3, 32768 bytes)
[    1.210000] TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
[    1.210000] TCP: Hash tables configured (established 4096 bind 4096)
[    1.220000] TCP reno registered
[    1.220000] UDP hash table entries: 256 (order: 0, 4096 bytes)
[    1.230000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[    1.240000] NET: Registered protocol family 1
[    1.550000] RT3xxx EHCI/OHCI init.
[    1.580000] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[    1.590000] JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
[    1.600000] msgmni has been set to 245
[    1.600000] io scheduler noop registered
[    1.600000] io scheduler deadline registered (default)
[    1.610000] Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled
[    1.620000] serial8250: ttyS0 at MMIO 0x10000500 (irq = 37) is a 16550A
[    1.620000] serial8250: ttyS1 at MMIO 0x10000c00 (irq = 12) is a 16550A
[    1.640000] brd: module loaded
[    1.650000] deice id : ef 40 18 0 0 (40180000)
[    1.650000] chip info: w25q128(ef 40180000)
[    1.660000] mtd name = raspi, size = 0x01000000 (16M) erasesize = 0x00010000 (64K)
[    1.670000] raspi: squash filesystem found at block 27
[    1.680000] bdinfo: fac txt empty, use default.
[    1.690000] Creating 9 MTD partitions on "raspi":
[    1.690000] 0x000000000000-0x000000030000 : "u-boot"
[    1.700000] mtdchar alloc 0x10000 memory success
[    1.700000] 0x000000030000-0x000000040000 : "hw_panic"
[    1.710000] 0x000000040000-0x000000050000 : "Factory"
[    1.720000] 0x000000050000-0x0000001b0000 : "kernel"
[    1.720000] 0x0000001b0000-0x000000fd0000 : "rootfs"
[    1.730000] mtd: partition "rootfs" set to be root filesystem
[    1.740000] mtd: partition "rootfs_data" created automatically, ofs=AE0000, len=4F0000
[    1.750000] 0x000000ae0000-0x000000fd0000 : "rootfs_data"
[    1.750000] 0x000000fd0000-0x000000fe0000 : "hwf_config"
[    1.760000] 0x000000fe0000-0x000000ff0000 : "bdinfo"
[    1.770000] 0x000000ff0000-0x000001000000 : "backup"
[    1.770000] 0x000000050000-0x000000fd0000 : "firmware"
[    1.780000] Ralink APSoC Ethernet Driver Initilization. v3.1  512 rx/tx descriptors allocated, mtu = 1500!
[    1.790000] SMACCR1 -- : 0x000000ba
[    1.790000] SMACCR0 -- : 0xbe000000
[    1.800000] PROC INIT OK!
[    1.800000] Stopped WatchDog Timer.
[    1.800000] Ralink APSoC Hardware Watchdog Timer
[    1.810000] MTK MSDC device init.
[    1.820000] msdc0 -> ops_get_cd return<0> <- msdc_ops_get_cd() : L<2327> PID<kworker/u:0><0x5>
[    1.820000] MediaTek MT6575 MSDC Driver
[    1.830000] TCP cubic registered
[    1.830000] NET: Registered protocol family 17
[    1.840000] 8021q: 802.1Q VLAN Support v1.8
[    1.840000] Freeing unused kernel memory: 372k freed
-HiWiFi initrd-
- preinit -
- regular preinit -
[    3.960000] JFFS2 notice: (467) jffs2_build_xattr_subsystem: complete building xattr subsystem, 1 of xdatum (1 unchecked, 0 orphan) and 125 of xref (0 dead, 103 orphan) found.
switching to jffs2
- init -

8404***

我的没有信息饿了