TTL信息 不知道问题出在哪里？高手给看看。

822***

CFE version 1.0.37 for BCM947XX (32bit,SP,LE)
Build Date: Fri Jan 18 15:59:34 CST 2008 (joseph@localhost)
Copyright (C) 2000,2001,2002,2003 Broadcom Corporation.

Initializing Arena
Initializing PCI. [normal]
PCI bus 0 slot 0/0: vendor 0x14e4 product 0x0800 (flash memory, rev 0x02)
PCI bus 0 slot 1/0: vendor 0x14e4 product 0x471f (ethernet network, rev 0x02)
PCI bus 0 slot 2/0: vendor 0x14e4 product 0x471a (USB serial bus, interface 0x10, rev 0x02)
PCI bus 0 slot 2/1: vendor 0x14e4 product 0x471a (USB serial bus, interface 0x20, rev 0x02)
PCI bus 0 slot 3/0: vendor 0x14e4 product 0x471b (USB serial bus, rev 0x02)
PCI bus 0 slot 4/0: vendor 0x14e4 product 0x0804 (PCI bridge, rev 0x02)
PCI bus 0 slot 5/0: vendor 0x14e4 product 0x0816 (MIPS processor, rev 0x02)
PCI bus 0 slot 6/0: vendor 0x14e4 product 0x471d (IDE mass storage, rev 0x02)
PCI bus 0 slot 7/0: vendor 0x14e4 product 0x4718 (network/computing crypto, rev 0x02)
PCI bus 0 slot 8/0: vendor 0x14e4 product 0x080f (RAM memory, rev 0x02)
PCI bus 0 slot 9/0: vendor 0x14e4 product 0x471e (class 0xfe, subclass 0x00, rev 0x02)
Initializing Devices.
Boot partition size = 262144(0x40000)
PCI bus 0 slot 1/0: pci_map_mem: attempt to map 64-bit region tag=0x800 @ addr=18010004
PCI bus 0 slot 1/0: pci_map_mem: addr=0x18010004 pa=0x18010000
ge0: BCM5750 Ethernet at 0x18010000
CPU type 0x2901A: 300MHz
Total memory: 32768 KBytes

Total memory used by CFE:  0x80300000 - 0x804066F0 (1074928)
Initialized Data:          0x80337C80 - 0x8033AC10 (12176)
BSS Area:                  0x8033AC10 - 0x8033C6F0 (6880)
Local Heap:                0x8033C6F0 - 0x804046F0 (819200)
Stack Area:                0x804046F0 - 0x804066F0 (8192)
Text (code) segment:       0x80300000 - 0x80337C80 (228480)
Boot area (physical):      0x00407000 - 0x00447000
Relocation Factor:         I:00000000 - D:00000000

eth0: Link speed: 1000BaseT FDX
Device eth0:  hwaddr 00-1E-E5-A6-C6-0B, ipaddr 192.168.1.1, mask 255.255.255.0
        gateway not set, nameserver not set
Loader:raw Filesys:tftp Dev:eth0 File:: Optionsnull)
Loading: Failed.
Could not load :: Timeout occured
Loader:raw Filesys:raw Dev:flash0.os File: Optionsnull)
Loading: ..... 2408448 bytes read
Entry at 0x80001000
Closing network.
eth0: cannot clear 1400/00000002
Starting program at 0x80001000
CPU revision is: 0002901a
Primary instruction cache 32kb, linesize 16 bytes (4 ways)
Primary data cache 32kb, linesize 16 bytes (2 ways)
Linux version 2.4.20 (joseph@localhost) (gcc version 3.2.3 with Broadcom modifications) #2781 き 5る 2 11:28:34 CST 2008
Setting the PFC to its default value
Determined physical RAM map:
memory: 02000000 @ 00000000 (usable)
On node 0 totalpages: 8192
zone(0): 8192 pages.
zone(1): 0 pages.
zone(2): 0 pages.
Kernel command line: root=/dev/mtdblock2 noinitrd console=ttyS0,115200
CPU: BCM4785 rev 2 at 300 MHz
Calibrating delay loop... 299.82 BogoMIPS
Memory: 29812k/32768k available (2116k kernel code, 2956k reserved, 136k data, 76k init, 0k highmem)
Dentry cache hash table entries: 4096 (order: 3, 32768 bytes)
Inode cache hash table entries: 2048 (order: 2, 16384 bytes)
Mount-cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer-cache hash table entries: 1024 (order: 0, 4096 bytes)
Page-cache hash table entries: 8192 (order: 3, 32768 bytes)
Checking for 'wait' instruction...  unavailable.
POSIX conformance testing by UNIFIX
PCI: Initializing host
PCI: Fixing up bus 0
PCI: Fixing up bridge
PCI: Fixing up bus 1
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
devfs: v1.12c (20020818) Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x1
squashfs: version 3.1 (2006/08/19) Phillip Lougher
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled
ttyS00 at 0xb8000300 (irq = 8) is a 16550A
ttyS01 at 0xb8000400 (irq = 0) is a 16550A
PPP generic driver version 2.4.2
PPP Deflate Compression module registered
PPP BSD Compression module registered
MPPE/MPPC encryption/compression module registered
SCSI subsystem driver Revision: 1.00
Amd/Fujitsu Extended Query Table v0.0 at 0x0040
Physically mapped flash: JEDEC Device ID is 0xE2. Assuming broken CFI table.
Physically mapped flash: Swapping erase regions for broken CFI table.
number of CFI chips: 1
Flash device: 0x800000 at 0x1c000000
Physically mapped flash: squashfs filesystem found at block 1277
Creating 5 MTD partitions on "hysically mapped flash":
0x00000000-0x00040000 : "boot"
0x00040000-0x007e0000 : "linux"
0x0013f430-0x007e0000 : "rootfs"
0x007e0000-0x007f0000 : "factory"
0x007f0000-0x00800000 : "nvram"
sflash: found no supported devices
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
hcd.c: ehci-hcd @ 00:02.1, PCI device 14e4:471a
hcd.c: irq 3, pci mem b8002800
usb.c: new USB bus registered, assigned bus number 1
hcd/ehci-hcd.c: USB 0.0 support enabled, EHCI rev 1. 0
hub.c: USB hub found
hub.c: 2 ports detected
usb-uhci.c: $Revision$ time 10:24:17 May  2 2008
usb-uhci.c: High bandwidth mode enabled
usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
usb-ohci.c: USB OHCI at membase 0xb8002000, IRQ 3
usb-ohci.c: usb-00:02.0, PCI device 14e4:471a
usb.c: new USB bus registered, assigned bus number 2
hub.c: USB hub found
hub.c: 2 ports detected
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
USB Mass Storage support registered.
IEEE 802.2 LLC for Linux 2.1 (c) 1996 Tim Alpaerts
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 2048 bind 4096)
Linux IP multicast router 0.06 plus PIM-SM
ip_conntrack version 2.1 (256 buckets, 2048 max) - 384 bytes per conntrack
ip_conntrack_rtsp v0.01 loading
ip_nat_rtsp v0.01 loading
ip_tables: (C) 2000-2002 Netfilter core team
ipt_time loading
ipt_trigger : register proc success
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
IPv6 v0.8 (usagi-cvs) for NET4.0
IPv6 over IPv4 tunneling driver
NET4: Ethernet Bridge 008 for NET4.0
802.1Q VLAN Support v1.7 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
FAT: bogus logical sector size 6884
UMSDOS: msdos_read_super failed, mount aborted.
FAT: bogus logical sector size 6884
FAT: bogus logical sector size 6884
VFS: Mounted root (squashfs filesystem) readonly.
Mounted devfs on /dev
Freeing unused kernel memory: 76k freed
Algorithmics/MIPS FPU Emulator v1.5
adduser: /home/admin: No such file or directory
adduser: /home/admin: No such file or directory
adduser: /home/admin: No such file or directory
Changing password for admin
Bad password: too simple.

Warning: weak password (continuing).
Password changed.
adduser: /home/guest: No such file or directory
adduser: /home/guest: No such file or directory
adduser: /home/guest: No such file or directory
Changing password for guest
Enter the new password (minimum of 5, maximum of 8 characters)
Please use a combination of upper and lower case letters and numbers.
Enter new password: Bad password: too short.

Warning: weak password (continuing).
Re-enter new password: Password changed.
ERROR: group admin already exists!
ERROR: group guest already exists!
Broadcom Gigabit Ethernet Driver bcm5700 with Broadcom NIC Extension (NICE) ver. 8.3.14 (11/2/05)
PHY ID unknown, assume it is a copper PHY.
eth0: Broadcom BCM4785 10/100/1000 Integrated Controller found at mem 18010000, IRQ 5, node addr 001ee5a6c60b
eth0: Unknown transceiver found
eth0: Scatter-gather ON, 64-bit DMA ON, Tx Checksum ON, Rx Checksum ON, 802.1Q VLAN ON, NAPI ON
PCI: Enabling device 01:01.0 (0004 -> 0006)
eth1: Broadcom BCM4329 802.11 Wireless Controller 4.158.4.0
PCI: Enabling device 01:02.0 (0004 -> 0006)
eth%d: 4.158.4.0 driver failed with code 11
ufsd: driver loaded
UFSD version 5.28 (Jun 25 2007, 10:45:03)
NTFS read/write support included

ufsd: address 0xc00fc060
Checking to see that USB initialization is done...
eth0: Using PCI INTX interrupt
device vlan1 entered promiscuous mode
device eth1 entered promiscuous mode
interface eth2 does not exist!
brctl addif br0 eth2: No such device
RC_ACTION = 1003
System Start...
eth2: No such device
ifconfig, eth2: No such device
eth1: Numerical result out of range
eth1: Numerical result out of range
eth1: Operation not supported
eth1: Operation not supported
eth1: Invalid argument
eth1: Invalid argument
eth1: Operation not supported
eth1: Operation not supported
eth1: Invalid argument
eth1: Invalid argument
eth1: Invalid argument
eth1: Invalid argument
eth1: Invalid argument
eth1: Invalid argument
eth1: Invalid argument
eth1: Invalid argument
eth1: Invalid argument
eth1: Invalid argument
eth1: Invalid argument
eth1: Invalid argument
eth1: Invalid argument
eth1: Invalid argument
eth1: Invalid argument
eth1: Invalid argument
wlconf eth2 down: No such device
eth2: No such device
wlconf eth2 up: No such device
*********************************************
Wi-Fi Simple Config Application - Intel Corp.
Version: Build 1.0.5, November 19 2006
*********************************************
Initializing stack... OK
Now starting stack
get mac = 00 1E E5 A6 C6 0A
DEVICE PIN: 17581028
(easytest.c->main(263)) Start easytest 20061221 14:23
(easytest.c->main(361)) Waiting product test packet...

(easyconf.c->main(640)) Dream: Start easyconf 20070725 17:48
(easyconf.c->main(729)) enter while(1)
Dante's tiny TFTP Server is ready on port 69
/tmp/del_route: cannot open