连接ttl报错了，大佬看看什么情况

shi429***

我刷k3c官改，已经出现S-S R之类的软件了，但是点击一下又回到主页面，反复刷了几次，路由器就无限重启，能够进入uboot,我就试着连接TTL，如果不按reset键开机，就报错无限循环，按住reset键就是如下提示，大佬们看看是不是nand需要更换了

1. ROM VER: 2.1.0
   
2. CFG 0a
   
3. B
   
4. .
   
5. .
   
6. 
   
7. 
   
8. U-Boot 2010.06-00244-g1aca8f6-LANTIQ-v-2.3.144 (Jan 31 2018 - 19:36:29)
   
9. 
   
10. interAptiv
    
11. cps cpu/ddr run in 800/666 Mhz
    
12. DRAM:  224 MiB
    
13. NAND:  Could not find valid JEDEC parameter page; aborting
    
14. NAND device: Manufacturer ID: 0xec, Chip ID: 0xf1 (Samsung NAND 128MiB 3,3V 8-bit)
    
15. 128 MiB
    
16. Bad block table found at page 65408, version 0x01
    
17. Bad block table found at page 65344, version 0x01
    
18. nand_read_bbt: Bad block at 0x000004060000
    
19. nand_read_bbt: Bad block at 0x000007fe0000
    
20. In:    serial
    
21. Out:   serial
    
22. Err:   serial
    
23. Net:   multi type
    
24. Internal phy firmware version: 0x8547
    
25. GRX500 Switch
    
26. 
    
27. Type "run flash_nfs" to mount root filesystem over NFS
    
28. 
    
29. 
    
30. Press press hardware button for more than 4 seconds to run web failsafe mode
    
31. 
    
32. 9 second(s)
    
33. 
    
34. hardware button was pressed for 9 seconds
    
35. HTTP server is starting for firmware update...
    
36. 
    
37. 
    
38. NetLoopHttpd,call eth_halt !
    
39. HTTP server is starting at IP: 192.168.2.1
    
40. HTTP server is ready!
    

复制代码

han***

不清楚，帮顶吧！！

心理***

50包邮回血

wycn***

不清楚，帮顶吧！！

hh***

重新刷机。。。。。