中兴 H218N 刷机 高手请帮看看

hynixcn

CFE version 5.60.120.9  based on BBP 1.0.37 for BCM947XX (32bit,SP,LE)
Build Date: 2011骞?06鏈?28鏃?鏄熸湡浜?17:42:41 CST (xialei@localhost.localdomain)
Copyright (C) 2000-2008 Broadcom Corporation.
Init Arena
Init Devs.
Boot partition size = 131072(0x20000)
Found a 16MB ST compatible serial flash
Serial flash offset 00000000 size 128KB
Serial flash offset 00020000 size 640KB
Serial flash offset 000C0000 size 1KB
Serial flash offset 000C0100 size 3456KB
Serial flash offset 00420000 size 1KB
Serial flash offset 00420100 size 12128KB
Serial flash offset 00FF8000 size 32KB
et0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.60.120.9
CPU type 0x19749: 500MHz
Tot mem: 65536 KBytes
CFE mem:    0x80700000 - 0x8079A240 (631360)
Data:       0x8072F7C0 - 0x80732CF0 (13616)
BSS:        0x80732CF0 - 0x80734240 (5456)
Heap:       0x80734240 - 0x80798240 (409600)
Stack:      0x80798240 - 0x8079A240 (8192)
Text:       0x80700000 - 0x8072F7B8 (194488)
Device eth0:  hwaddr 00-90-4C-01-60-04, ipaddr 192.168.1.254, mask 255.255.255.0
        gateway not set, nameserver not set
reset key is pressed
*** Press 1 means entering boot mode***
Press 2 means entering testing mode***
Press 3 means entering norm mode***
Hit key to stop autoboot: 03 Entering boot mode ...
Startup canceled
CFE> flash -noheader 192.168.1.55:/cfe.bin flash0.boot
Reading 192.168.1.55:/cfe.bin: TFTP error 2: Access violation
Failed.: Network protocol error
*** command status = -22
CFE> flash -noheader 192.168.1.55:/tt.bin flash0.trx
Reading 192.168.1.55:/tt.bin: TFTP error 2: Access violation
Failed.: Network protocol error
*** command status = -22
CFE> flash -noheader 192.168.1.55:/cfe.bin flash0.boot
Reading 192.168.1.55:/cfe.bin: TFTP error 2: Access violation
Failed.: Network protocol error
*** command status = -22
CFE> flash -noheader 192.168.1.55:/tt.bin flash0.trx
Reading 192.168.1.55:/tt.bin: TFTP error 2: Access violation
Failed.: Network protocol error
*** command status = -22
CFE> flash -noheader 192.168.1.55:/tttt.bin flash0.trx
Reading 192.168.1.55:/tttt.bin: TFTP error 2: Access violation
Failed.: Network protocol error
*** command status = -22
CFE>

hynixcn

TTL上刷入RG200E的cef 失败  请教高手 怎么弄 那里弄错了

hysn

支持.................

hynixcn

CFE> flash -noheader 192.168.1.55:/tttt.bin flash0.trx
Reading 192.168.1.55:/tttt.bin: TFTP error 2: Access violation
Failed.: Network protocol error
*** command status = -22

hynixcn

tftpd32 显示
connection received from 192.168.1.254 on port 3614
read request fot file</cfe.bin>.Mode octet
Error : EACCESS.Ext error 目录名无效

hynixcn

文件目录放在 D:\11 文件夹下 我自己的ip是192.168.1.55

hynixcn

求指导

fanz

没看到有运行 tftp server 哦？这个必须的，而且要把 tftp server 的根目录（或许叫当前目录）定位至 cfe.bin 存放路径...

瀛岛老农

fanz 发表于 2012-5-22 17:04
没看到有运行 tftp server 哦？这个必须的，而且要把 tftp server 的根目录（或许叫当前目录）定位至 cfe.b ...

运行 tftp server后,也出现tftpd32 显示
connection received from 192.168.1.254 on port 3614
read request fot file</cfe.bin>.Mode octet
Error : EACCESS.Ext error 目录名无效

请高手出手相助

瀛岛老农

fanz 发表于 2012-5-22 17:04
没看到有运行 tftp server 哦？这个必须的，而且要把 tftp server 的根目录（或许叫当前目录）定位至 cfe.b ...

{:soso_e130:}运行 tftp server后,也出现tftpd32 显示
connection received from 192.168.1.254 on port 3614
read request fot file</cfe.bin>.Mode octet
Error : EACCESS.Ext error 目录名无效

请高手出手相助