|
半月前购入一台二手HG320和一台H218N,机器的cfe和固件都是独舞TT,两台机都更改了MAC地址,将H218N刷了sady的cfe和磊科235W的固件做主路由,HG320打算做脱机下载用,刷入的是独舞的cfe和独舞的0523 full版本的TT,那段时间没时间折腾路由器,就把HG320放家里一直闲置,前两天开始看教程做脱机下载的外挂程序,HG320连接H218N,关掉了HG320的dhcp,关了无线,将HG320IP设置在192.168.1.2,结果发现连不上路由器,按住restart键恢复出厂设置不行,就在miniweb下重刷系统,结果发现点击固件升级也没上传,无奈关了路由器打算重刷,结果就悲剧了…………
至此以后,路由器开机语音等亮,lan口灯正常,无线等常亮,路由器开机时ping路由能看到ttl=100,能进miniweb,miniweb下也能刷系统,可是就是ping通几次ttl=100之后路由器就在也ping不通了,固定ip、自动获取ip都不行。之前有人告诉我这样只能在ttl下刷新cfe才行,就跑去买了ttl,结果问题依旧……无奈之下,拆flash上编程器,编程器清空flash后刷入cfe再在miniweb下刷入固件,结果还是一样……现附上ttl启动信息,看哪位大神能帮忙看看- Decompressing...done
- CFE version 5.60.120.9 based on BBP 1.0.37 for BCM947XX (32bit,SP,LE)
- Build Date: 2011骞05鏈04鏃鏄熸湡涓15:32:36 CST (root@localhost.localdomain)
- Copyright (C) 2000-2008 Broadcom Corporation.
- Init Arena
- Init Devs.
- Boot partition size = 131072(0x20000)
- Found a 16MB ST compatible serial flash
- [CFE][boot][ST Serial flash offset 00000000 size 128KB]
- [CFE][trx][ST Serial flash offset 00020000 size 1KB]
- [CFE][os][ST Serial flash offset 0002001C size 16224KB]
- [CFE][nvram][ST Serial flash offset 00FF8000 size 32KB]
- [CFE][boot][ST Serial flash offset 00000000 size 128KB]
- [CFE][trx0][ST Serial flash offset 00020000 size 1KB]
- [CFE][os0][ST Serial flash offset 0002001C size 8832KB]
- [CFE][trx1][ST Serial flash offset 008C0000 size 1KB]
- [CFE][os1][ST Serial flash offset 008C001C size 7392KB]
- [CFE][nvram][ST Serial flash offset 00FF8000 size 32KB]
- et0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.60.120.9
- CPU type 0x19749: 500MHz
- Tot mem: 65536 KBytes
- CFE mem: 0x80700000 - 0x8079A7D0 (632784)
- Data: 0x807306D0 - 0x80733850 (12672)
- BSS: 0x80733850 - 0x807347D0 (3968)
- Heap: 0x807347D0 - 0x807987D0 (409600)
- Stack: 0x807987D0 - 0x8079A7D0 (8192)
- Text: 0x80700000 - 0x807306C8 (198344)
- Device eth0: hwaddr 00-0A-C2-ED-FE-1F, ipaddr 192.168.1.1, mask 255.255.255.0
- gateway not set, nameserver not set
- cur=
- buf=go;
- Loader:raw Filesys:tftp Dev:eth0 File:: Options:(null)
- Loading: Failed.
- Could not load :: Timeout occured
- Boot from big image !!
- Loader:raw Filesys:raw Dev:flash0.os File: Options:(null)
- Loading: .. 5192 bytes read
- Entry at 0x80001000
- Closing network.
- Starting program at 0x80001000
- Linux version 2.6.22.19 (root@tomato) (gcc version 4.2.4) #11 Fri May 3 13:39:44 CST 2013
- CPU revision is: 00019749
- Determined physical RAM map:
- memory: 04000000 @ 00000000 (usable)
- Zone PFN ranges:
- Normal 0 -> 16384
- HighMem 16384 -> 16384
- early_node_map[1] active PFN ranges
- 0: 0 -> 16384
- Built 1 zonelists. Total pages: 16384
- Kernel command line: root=/dev/mtdblock2 noinitrd console=ttyS0,115200
- Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes.
- Primary data cache 32kB, 4-way, linesize 32 bytes.
- Synthesized TLB refill handler (20 instructions).
- Synthesized TLB load handler fastpath (32 instructions).
- Synthesized TLB store handler fastpath (32 instructions).
- Synthesized TLB modify handler fastpath (31 instructions).
- PID hash table entries: 512 (order: 9, 2048 bytes)
- CPU: BCM5357 rev 1 pkg 9 at 500 MHz
- Using 250.000 MHz high precision timer.
- console [ttyS0] enabled
- Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
- Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
- Memory: 61244k/65536k available (33k kernel code, 4232k reserved, 2786k data, 128k init, 0k highmem)
- Mount-cache hash table entries: 512
- NET: Registered protocol family 16
- PCI: no core
- PCI: no core
- PCI: Fixing up bus 0
- NET: Registered protocol family 2
- Time: MIPS clocksource has been installed.
- IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
- TCP established hash table entries: 2048 (order: 2, 16384 bytes)
- TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
- TCP: Hash tables configured (established 2048 bind 2048)
- TCP reno registered
- squashfs: version 3.0 (2006/03/15) Phillip Lougher
- io scheduler noop registered (default)
- HDLC line discipline: version $Revision: 4.8 $, maxframe=4096
- N_HDLC line discipline registered.
- Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled
- serial8250: ttyS0 at MMIO 0xb8000300 (irq = 8) is a 16550A
- loop: module loaded
- PPP generic driver version 2.4.2
- MPPE/MPPC encryption/compression module registered
- NET: Registered protocol family 24
- PPPoL2TP kernel driver, V0.18.3
- PPTP driver version 0.8.5
- pflash: found no supported devices
- Found an ST compatible serial flash with 256 64KB blocks; total size 16MB
- Creating 5 MTD partitions on "sflash":
- 0x00000000-0x00020000 : "pmon"
- 0x00020000-0x00ff0000 : "linux"
- 0x0010d400-0x008d0000 : "rootfs"
- 0x008d0000-0x00ff0000 : "jffs2"
- 0x00ff0000-0x01000000 : "nvram"
- _nvram_init: allocat header: 2166161408, size= 32768
- u32 classifier
- OLD policer on
- Netfilter messages via NETLINK v0.30.
- nf_conntrack version 0.5.0 (512 buckets, 4096 max)
- ip_tables: (C) 2000-2006 Netfilter Core Team
- ipt_account 0.1.21 : Piotr Gasidlo <quaker@barbara.eu.org>, http://www.barbara.eu.org/~quaker/ipt_account/
- net/ipv4/netfilter/tomato_ct.c [May 3 2013 13:39:07]
- NET: Registered protocol family 1
- NET: Registered protocol family 10
- ip6_tables: (C) 2000-2006 Netfilter Core Team
- NET: Registered protocol family 17
- 802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
- All bugs added by David S. Miller <davem@redhat.com>
- VFS: Mounted root (squashfs filesystem) readonly.
- Freeing unused kernel memory: 128k freed
- Warning: unable to open an initial console.
- emf: module license 'Proprietary' taints kernel.
- eth0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.100.138.20
- wl_module_init: passivemode set to 0x0
复制代码 还有一点,现在的路由器启动后过上两分钟,cpu散热片上摸着烫手。
|
|