昨天多拨成功，今天重拨之后多拨失败，求破

raychen10

我把双拨改为了3拨，失败之后改回双拨但是始终失败，求各位大神帮忙看看什么原因啊

WMAN3配置：
config interface 'wan'
        option enabled '1'
        option count '1'
        option timeout '2'
        option interval '5'
        option down '3'
        option up '8'
        list track_ip '114.114.114.114'
        list track_ip '114.114.115.115'
        option reliability '1'

config policy 'balanced'
        list use_member 'wan_m1_w1'
        list use_member 'vwan1_m1_w1'

config rule 'default_rule'
        option dest_ip '0.0.0.0/0'
        option use_policy 'balanced'
        option proto 'all'

config member 'wan_m1_w1'
        option interface 'wan'
        option metric '1'
        option weight '1'

config interface 'vwan1'
        option enabled '1'
        option count '1'
        option timeout '2'
        option interval '5'
        option down '3'
        option up '8'
        list track_ip '114.114.114.114'
        list track_ip '114.114.115.115'
        option reliability '1'

config member 'vwan1_m1_w1'
        option interface 'vwan1'
        option metric '1'
        option weight '1'

network配置：
config interface 'loopback'
        option ifname 'lo'
        option proto 'static'
        option ipaddr '127.0.0.1'
        option netmask '255.0.0.0'

config globals 'globals'
        option ula_prefix 'fd37:003b:c7c0::/48'

config interface 'lan'
        option ifname 'eth0'
        option force_link '1'
        option type 'bridge'
        option proto 'static'
        option ipaddr '192.168.1.1'
        option netmask '255.255.255.0'
        option ip6assign '60'

config interface 'wan'
        option ifname 'eth1'
        option _orig_ifname 'eth1'
        option _orig_bridge 'false'
        option proto 'pppoe'
        option username 'lan******'
        option password '******'
        option metric '40'

config interface 'wan6'
        option ifname '@wan'
        option proto 'dhcpv6'

config switch
        option name 'switch0'
        option reset '1'
        option enable_vlan '1'

config switch_vlan
        option device 'switch0'
        option vlan '1'
        option ports '1 2 3 4 6t'

config interface 'vwan1'
        option ifname 'vth1'
        option proto 'pppoe'
        option username 'lan******'
        option password '******'
        option metric '41'

请不要胡乱输入以及粘贴、复制等方式灌水

请尊重作者、并共同维护网站的正常阅读，否则账户将会被限制发帖、回帖，并且积分可能会被清零，站内短信以及阅读权限等都会受到影响，谢谢。 具体限制方式：https://www.right.com.cn/forum/thread-8307840-1-1.html

raychen10

显示的错误是WARNING: some interfaces have no default route in the main routing table!

jonepjxh

wman3是用来叠加的不是用来多拨的