本帖最后由 plym567 于 2015-4-9 15:49 编辑
家中两条网线,一条电信20M(FTTB+LAN,不带光猫,直接拨号),一条联通20M(FTTH,带光猫,但是光猫不拨号,我都是接到路由器或者电脑上拨号),
本人菜鸟一只,这两天经过高手指点终于搞定了chinaDNS+SS海淘,家中有两条网线,正好想要利用下资源,叠加一下网速,然后实战,碰到难题,希望高手解答。
本人使用的两个路由器,
1、极路由2(接的联通线路,使用正常);
2、网件4300+OpenWRT(接的电信线路,使用正常)
今天研究了下叠加,想试试我的联通线路支不支持多拨,于是把联通线路从极路由上拔下,直接插入OPENWRT的WAN口,进OP设置WAN口信息,把账号密码都改成了联通的(核对了一百遍,绝对没错),然后点击连接,没反应
后来得知我光猫的IP地址,192.168.1.1和我OPENWRT可能冲突,于是把OPENWRT的LAN口地址改成了192.168.0.1,然后重启,拨号,还是没反应。
于是自己测试了下,
拔下联通那根网线直接接到电脑上,拨号成功;
插入极路由,也是拨号成功;
最后插入OPENWRT路由,拨号无反应。
最后的最后,把原本的电信线路查到OPENWRT上,拨号成功。
现在问题来了,为什么联通线路查到OPENWRT上就无法拨号,求助大神。纠结了大半夜的问题,实在搞不懂。
=============================================================================
附上系统日志和内核日志:
系统日志:
Thu Apr 9 15:35:13 2015 daemon.notice netifd: Interface 'wan' is now down
Thu Apr 9 15:35:13 2015 daemon.notice netifd: Interface 'wan' is disabled
Thu Apr 9 15:35:13 2015 daemon.notice netifd: Interface 'wan' is enabled
Thu Apr 9 15:35:13 2015 daemon.notice netifd: Interface 'wan' is setting up now
Thu Apr 9 15:35:13 2015 daemon.notice netifd: VLAN 'eth0.2' link is down
Thu Apr 9 15:35:13 2015 daemon.notice netifd: Interface 'wan' has link connectivity loss
Thu Apr 9 15:35:13 2015 daemon.notice netifd: VLAN 'eth0.2' link is up
Thu Apr 9 15:35:13 2015 daemon.notice netifd: Interface 'wan' has link connectivity
Thu Apr 9 15:35:13 2015 daemon.info pppd[17208]: Plugin rp-pppoe.so loaded.
Thu Apr 9 15:35:13 2015 daemon.info pppd[17208]: RP-PPPoE plugin version 3.8p compiled against pppd 2.4.7
Thu Apr 9 15:35:13 2015 daemon.notice pppd[17208]: pppd 2.4.7 started by root, uid 0
Thu Apr 9 15:35:28 2015 daemon.warn pppd[17208]: Timeout waiting for PADO packets
Thu Apr 9 15:35:28 2015 daemon.err pppd[17208]: Unable to complete PPPoE Discovery
Thu Apr 9 15:35:28 2015 daemon.info pppd[17208]: Exit.
Thu Apr 9 15:35:28 2015 daemon.notice netifd: Interface 'wan' is now down
Thu Apr 9 15:35:28 2015 daemon.notice netifd: Interface 'wan' is disabled
Thu Apr 9 15:35:28 2015 daemon.notice netifd: Interface 'wan' is enabled
Thu Apr 9 15:35:28 2015 daemon.notice netifd: Interface 'wan' is setting up now
Thu Apr 9 15:35:28 2015 daemon.notice netifd: VLAN 'eth0.2' link is down
Thu Apr 9 15:35:28 2015 daemon.notice netifd: Interface 'wan' has link connectivity loss
Thu Apr 9 15:35:28 2015 daemon.notice netifd: VLAN 'eth0.2' link is up
Thu Apr 9 15:35:28 2015 daemon.notice netifd: Interface 'wan' has link connectivity
Thu Apr 9 15:35:28 2015 daemon.info pppd[17283]: Plugin rp-pppoe.so loaded.
Thu Apr 9 15:35:28 2015 daemon.info pppd[17283]: RP-PPPoE plugin version 3.8p compiled against pppd 2.4.7
Thu Apr 9 15:35:28 2015 daemon.notice pppd[17283]: pppd 2.4.7 started by root, uid 0
Thu Apr 9 15:35:44 2015 daemon.warn pppd[17283]: Timeout waiting for PADO packets
Thu Apr 9 15:35:44 2015 daemon.err pppd[17283]: Unable to complete PPPoE Discovery
Thu Apr 9 15:35:44 2015 daemon.info pppd[17283]: Exit.
Thu Apr 9 15:35:44 2015 daemon.notice netifd: Interface 'wan' is now down
Thu Apr 9 15:35:44 2015 daemon.notice netifd: Interface 'wan' is disabled
Thu Apr 9 15:35:44 2015 daemon.notice netifd: Interface 'wan' is enabled
Thu Apr 9 15:35:44 2015 daemon.notice netifd: Interface 'wan' is setting up now
Thu Apr 9 15:35:44 2015 daemon.notice netifd: VLAN 'eth0.2' link is down
Thu Apr 9 15:35:44 2015 daemon.notice netifd: Interface 'wan' has link connectivity loss
Thu Apr 9 15:35:44 2015 daemon.notice netifd: VLAN 'eth0.2' link is up
Thu Apr 9 15:35:44 2015 daemon.notice netifd: Interface 'wan' has link connectivity
Thu Apr 9 15:35:44 2015 daemon.info pppd[17357]: Plugin rp-pppoe.so loaded.
Thu Apr 9 15:35:44 2015 daemon.info pppd[17357]: RP-PPPoE plugin version 3.8p compiled against pppd 2.4.7
Thu Apr 9 15:35:44 2015 daemon.notice pppd[17357]: pppd 2.4.7 started by root, uid 0
=======================================================================
内核日志:
[ 33.190000] eth0: link up (1000Mbps/Full duplex)
[ 33.230000] br-lan: port 1(eth0.1) entered forwarding state
[ 33.230000] br-lan: port 1(eth0.1) entered forwarding state
[ 34.460000] device wlan1 entered promiscuous mode
[ 34.470000] br-lan: port 2(wlan1) entered forwarding state
[ 34.470000] br-lan: port 2(wlan1) entered forwarding state
[ 34.610000] br-lan: port 2(wlan1) entered disabled state
[ 34.660000] device wlan0 entered promiscuous mode
[ 34.660000] br-lan: port 3(wlan0) entered forwarding state
[ 34.670000] br-lan: port 3(wlan0) entered forwarding state
[ 35.230000] br-lan: port 1(eth0.1) entered forwarding state
[ 35.730000] br-lan: port 3(wlan0) entered disabled state
[ 36.360000] br-lan: port 2(wlan1) entered forwarding state
[ 36.360000] br-lan: port 2(wlan1) entered forwarding state
[ 36.450000] br-lan: port 3(wlan0) entered forwarding state
[ 36.450000] br-lan: port 3(wlan0) entered forwarding state
[ 38.360000] br-lan: port 2(wlan1) entered forwarding state
[ 38.450000] br-lan: port 3(wlan0) entered forwarding state
[ 398.710000] device wlan0 left promiscuous mode
[ 398.710000] br-lan: port 3(wlan0) entered disabled state
[ 400.630000] device wlan0 entered promiscuous mode
[ 402.470000] br-lan: port 3(wlan0) entered forwarding state
[ 402.470000] br-lan: port 3(wlan0) entered forwarding state
[ 404.470000] br-lan: port 3(wlan0) entered forwarding state
[ 486.880000] device wlan1 left promiscuous mode
[ 486.880000] br-lan: port 2(wlan1) entered disabled state
[ 488.470000] device wlan1 entered promiscuous mode
[ 489.710000] br-lan: port 2(wlan1) entered forwarding state
[ 489.710000] br-lan: port 2(wlan1) entered forwarding state
[ 491.710000] br-lan: port 2(wlan1) entered forwarding state
[ 4741.990000] nf_conntrack: automatic helper assignment is deprecated and it will be removed soon. Use
the iptables CT target to attach helpers instead.
[ 8424.170000] ath: phy0: Timeout while waiting for nf to load: AR_PHY_AGC_CONTROL=0x1d0dda
[16959.830000] ath: phy0: Timeout while waiting for nf to load: AR_PHY_AGC_CONTROL=0x1d0dda
[23006.670000] ath: phy0: Timeout while waiting for nf to load: AR_PHY_AGC_CONTROL=0x1d0dda
[23643.910000] ath: phy0: Timeout while waiting for nf to load: AR_PHY_AGC_CONTROL=0x1d0dda
[32302.270000] ath: phy0: Timeout while waiting for nf to load: AR_PHY_AGC_CONTROL=0x1d0dda
[33498.330000] ath: phy0: Timeout while waiting for nf to load: AR_PHY_AGC_CONTROL=0x1d0dda
[37355.570000] ath: phy0: Timeout while waiting for nf to load: AR_PHY_AGC_CONTROL=0x1d0dda
[50191.880000] ath: phy0: Timeout while waiting for nf to load: AR_PHY_AGC_CONTROL=0x1d0dda
请不要胡乱输入以及粘贴、复制等方式灌水
请尊重作者、并共同维护网站的正常阅读,否则账户将会被限制发帖、回帖,并且积分可能会被清零,站内短信以及阅读权限等都会受到影响,谢谢。
具体限制方式:https://www.right.com.cn/forum/thread-8307840-1-1.html
|