WDR5600V2刷WDR6500V2的openwrt没有5G如何解决

chinacool

[    0.000000] Linux version 4.4.14 (openwrt@ubuntu-virtual-machine) (gcc version 5.3.0 (OpenWrt GCC 5.3.0 49928) ) #1 Fri Sep 9 10:37:09 UTC 2016
[    0.000000] bootconsole [early0] enabled
[    0.000000] CPU0 revision is: 00019750 (MIPS 74Kc)
[    0.000000] SoC: Qualcomm Atheros QCA956X ver 1 rev 0
[    0.000000] Determined physical RAM map:
[    0.000000]  memory: 04000000 @ 00000000 (usable)
[    0.000000] Initrd not found or empty - disabling initrd
[    0.000000] No valid device tree found, continuing without
[    0.000000] Zone ranges:
[    0.000000]   Normal   [mem 0x0000000000000000-0x0000000003ffffff]
[    0.000000] Movable zone start for each node
[    0.000000] Early memory node ranges
[    0.000000]   node   0: [mem 0x0000000000000000-0x0000000003ffffff]
[    0.000000] Initmem setup node 0 [mem 0x0000000000000000-0x0000000003ffffff]
[    0.000000] On node 0 totalpages: 16384
[    0.000000] free_area_init_node: node 0, pgdat 803dc3d0, node_mem_map 81000000
[    0.000000]   Normal zone: 128 pages used for memmap
[    0.000000]   Normal zone: 0 pages reserved
[    0.000000]   Normal zone: 16384 pages, LIFO batch:3
[    0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
[    0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
[    0.000000] pcpu-alloc: s0 r0 d32768 u32768 alloc=1*32768
[    0.000000] pcpu-alloc: [0] 0
[    0.000000] Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 16256
[    0.000000] Kernel command line:  board=TL-WDR5600-v2  console=ttyS0,115200 rootfstype=squashfs,jffs2 noinitrd
[    0.000000] PID hash table entries: 256 (order: -2, 1024 bytes)
[    0.000000] Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
[    0.000000] Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
[    0.000000] Writing ErrCtl register=00000000
[    0.000000] Readback ErrCtl register=00000000
[    0.000000] Memory: 60496K/65536K available (2840K kernel code, 120K rwdata, 692K rodata, 180K init, 191K bss, 5040K reserved, 0K cma-reserved)
[    0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
[    0.000000] NR_IRQS:51
[    0.000000] Clocks: CPU:750.000MHz, DDR:650.000MHz, AHB:250.000MHz, Ref:25.000MHz
[    0.000000] clocksource: MIPS: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 5096694524 ns
[    0.000007] sched_clock: 32 bits at 375MHz, resolution 2ns, wraps every 5726622718ns
[    0.008828] Calibrating delay loop... 373.55 BogoMIPS (lpj=1867776)
[    0.071925] pid_max: default: 32768 minimum: 301
[    0.077264] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes)
[    0.084781] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes)
[    0.094953] clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 19112604462750000 ns
[    0.106689] NET: Registered protocol family 16
[    0.112689] MIPS: machine is TP-LINK TL-WDR5600 v2
[    0.568726] clocksource: Switched to clocksource MIPS
[    0.575487] NET: Registered protocol family 2
[    0.581098] TCP established hash table entries: 1024 (order: 0, 4096 bytes)
[    0.589059] TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
[    0.596273] TCP: Hash tables configured (established 1024 bind 1024)
[    0.603576] UDP hash table entries: 256 (order: 0, 4096 bytes)
[    0.610241] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[    0.617608] NET: Registered protocol family 1
[    0.623418] futex hash table entries: 256 (order: -1, 3072 bytes)
[    0.643354] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[    0.650031] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
[    0.663232] io scheduler noop registered
[    0.667692] io scheduler deadline registered (default)
[    0.673707] Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
[    0.681276] console [ttyS0] disabled
[    0.705410] serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11, base_baud = 1562500) is a 16550A
[    0.715201] console [ttyS0] enabled
[    0.722752] bootconsole [early0] disabled
[    0.733612] m25p80 spi0.0: found s25fl064k, expected m25p80
[    0.739428] m25p80 spi0.0: s25fl064k (8192 Kbytes)
[    0.745441] 5 tp-link-64k partitions found on MTD device spi0.0
[    0.751599] Creating 5 MTD partitions on "spi0.0":
[    0.756548] 0x000000000000-0x000000010000 : "u-boot"
[    0.762846] 0x000000010000-0x0000001423b4 : "kernel"
[    0.769313] 0x0000001423b4-0x0000007f0000 : "rootfs"
[    0.775709] mtd: device 2 (rootfs) set to be root filesystem
[    0.781672] 1 squashfs-split partitions found on MTD device rootfs
[    0.788061] 0x000000370000-0x0000007f0000 : "rootfs_data"
[    0.794973] 0x0000007f0000-0x000000800000 : "art"
[    0.801184] 0x000000010000-0x0000007f0000 : "firmware"
[    0.823603] libphy: ag71xx_mdio: probed
[    1.411197] ag71xx ag71xx.0: connected to PHY at ag71xx-mdio.1:04 [uid=004dd042, driver=Generic PHY]
[    1.421194] eth0: Atheros AG71xx at 0xb9000000, irq 4, mode:MII
[    2.010910] ag71xx-mdio.1: Found an AR934X built-in switch
[    2.053578] eth1: Atheros AG71xx at 0xba000000, irq 5, mode:GMII
[    2.061644] NET: Registered protocol family 10
[    2.069732] NET: Registered protocol family 17
[    2.074391] bridge: automatic filtering via arp/ip/ip6tables has been deprecated. Update your scripts to load br_netfilter if you need this.
[    2.087562] 8021q: 802.1Q VLAN Support v1.8
[    2.097582] VFS: Mounted root (squashfs filesystem) readonly on device 31:2.
[    2.105908] Freeing unused kernel memory: 180K (803f3000 - 80420000)
[    3.167482] init: Console is alive
[    3.171232] init: - watchdog -
[    3.985752] init: - preinit -
[    4.488119] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[    4.510406] random: procd urandom read with 7 bits of entropy available
[    7.732419] jffs2: notice: (337) jffs2_build_xattr_subsystem: complete building xattr subsystem, 0 of xdatum (0 unchecked, 0 orphan) and 0 of xref (0 dead, 0 orphan) found.
[    7.749890] mount_root: switching to jffs2 overlay
[    7.792646] procd: - early -
[    7.795714] procd: - watchdog -
[    8.450591] procd: - ubus -
[    8.507339] procd: - init -
[    9.093612] ip6_tables: (C) 2000-2006 Netfilter Core Team
[    9.109615] Loading modules backported from Linux version wt-2016-05-12-0-g7a54796
[    9.117439] Backport generated by backports.git backports-20160216-0-ge3c56e4
[    9.127421] ip_tables: (C) 2000-2006 Netfilter Core Team
[    9.141033] nf_conntrack version 0.5.0 (948 buckets, 3792 max)
[    9.176669] xt_time: kernel timezone is -0000
[    9.229045] PPP generic driver version 2.4.2
[    9.235606] NET: Registered protocol family 24
[    9.278873] ath: EEPROM regdomain: 0x0
[    9.278890] ath: EEPROM indicates default country code should be used
[    9.278897] ath: doing EEPROM country->regdmn map search
[    9.278914] ath: country maps to regdmn code: 0x3a
[    9.278923] ath: Country alpha2 being used: US
[    9.278929] ath: Regpair used: 0x3a
[    9.289620] ieee80211 phy0: Selected rate control algorithm 'minstrel_ht'
[    9.292595] ieee80211 phy0: Atheros AR9561 Rev:0 mem=0xb8100000, irq=47
[   16.088663] device eth1 entered promiscuous mode
[   16.099816] br-lan: port 1(eth1) entered forwarding state
[   16.105423] br-lan: port 1(eth1) entered forwarding state
[   16.142449] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[   17.048396] br-lan: port 1(eth1) entered disabled state
[   17.680616] eth1: link up (1000Mbps/Full duplex)
[   17.685437] br-lan: port 1(eth1) entered forwarding state
[   17.691082] br-lan: port 1(eth1) entered forwarding state
[   18.543764] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   18.585261] device wlan0 entered promiscuous mode
[   19.688731] br-lan: port 1(eth1) entered forwarding state
[   20.160323] IPv6: ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[   20.167037] br-lan: port 2(wlan0) entered forwarding state
[   20.172773] br-lan: port 2(wlan0) entered forwarding state
[   22.168758] br-lan: port 2(wlan0) entered forwarding state
[   40.738777] random: nonblocking pool is initialized

请不要胡乱输入以及粘贴、复制等方式灌水

请尊重作者、并共同维护网站的正常阅读，否则账户将会被限制发帖、回帖，并且积分可能会被清零，站内短信以及阅读权限等都会受到影响，谢谢。 具体限制方式：https://www.right.com.cn/forum/thread-8307840-1-1.html

zjboy1984

请问下wdr5600刷机成功了吗，能否共享下固件，谢谢

PLA_star

请问下，5600v2的机子，怎么刷的？需要拆机吗？

fishtorres

WDR5600V2是什么网卡

bjxqkx

能否共享下WDR5600V2固件