|
|
楼主 |
发表于 2012-11-24 16:21
|
显示全部楼层
本帖最后由 acamar 于 2012-11-24 16:22 编辑
贴一段启动的日志：
Boot from main system!
## Booting image at bf020000 ...
Image Name: MIPS OpenWrt Linux-2.6.32.59
Image Type: MIPS Linux Kernel Image (lzma compressed)
Data Size: 804230 Bytes = 785.4 kB
Load Address: 80000000
Entry Point: 80000000
Verifying Checksum ... OK
IH_COMP_LZMA Uncompressing Kernel Image ... OK
No initrd
## Transferring control to Linux (at address 80000000) ...
## Giving linux memsize in MB, 32
Starting kernel ...
Linux version 2.6.32.59 (acamar#gmail.com) (gcc version 4.3.3 (GCC) ) #34 Sat Nov 24 14:45:32 CST 2012
bootconsole [early0] enabled
CPU revision is: 0001964c (MIPS 24Kc)
Ralink RT3052 id:1 rev:3 running at 384.00 MHz
Determined physical RAM map:
memory: 02000000 @ 00000000 (usable)
Initrd not found or empty - disabling initrd
Zone PFN ranges:
Normal 0x00000000 -> 0x00002000
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
0: 0x00000000 -> 0x00002000
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128
Kernel command line: console=ttyS1,57600 rootfstype=squashfs,jffs2 board=HG255D console=ttyS1,57600 mtdparts=physmap-flash.0:128k(u-boot)ro,1024k(kernel),0x600000(rootfs),128k@0xfa0000(factory),0xe60000@0x20000(firmware)ro,16384k@0x00000(fullflash)
PID hash table entries: 128 (order: -3, 512 bytes)
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Primary instruction cache 32kB, VIPT, 4-way, linesize 32 bytes.
Primary data cache 16kB, 4-way, VIPT, no aliases, linesize 32 bytes
Writing ErrCtl register=00070100
Readback ErrCtl register=00070100
Memory: 29988k/32768k available (1891k kernel code, 2780k reserved, 341k data, 140k init, 0k highmem)
SLUB: Genslabs=7, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
Hierarchical RCU implementation.
NR_IRQS:48
console [ttyS1] enabled, bootconsole disabled
console [ttyS1] enabled, bootconsole disabled
Calibrating delay loop... 255.59 BogoMIPS (lpj=1277952)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
MIPS: machine is HuaWei HG255D
bio: create slab <bio-0> at 0
Switching to clocksource MIPS
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP reno registered
NET: Registered protocol family 1
squashfs: version 4.0 (2009/01/31) Phillip Lougher
Registering mini_fo version $Id$
JFFS2 version 2.2. (NAND) (SUMMARY) © 2001-2006 Red Hat, Inc.
msgmni has been set to 58
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0x10000500 (irq = 13) is a 16550A
serial8250: ttyS1 at MMIO 0x10000c00 (irq = 20) is a 16550A
physmap platform flash device: 01000000 at bf000000
physmap-flash.0: Found 1 x16 devices at 0x0 in 16-bit bank
CFI mfr 0x00000001
CFI id 0x00002101
Amd/Fujitsu Extended Query Table at 0x0040
Amd/Fujitsu Extended Query version 1.3.
physmap-flash.0: CFI does not contain boot bank location. Assuming top.
number of CFI chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
6 cmdlinepart partitions found on MTD device physmap-flash.0
Creating 6 MTD partitions on "physmap-flash.0":
0x000000000000-0x000000020000 : "u-boot"
0x000000020000-0x000000120000 : "kernel"
0x000000120000-0x000000720000 : "rootfs"
mtd: partition "rootfs" set to be root filesystem
mtd: partition "rootfs_data" created automatically, ofs=5E0000, len=140000
0x0000005e0000-0x000000720000 : "rootfs_data"
0x000000fa0000-0x000000fc0000 : "factory"
0x000000020000-0x000000e80000 : "firmware"
0x000000000000-0x000001000000 : "fullflash"
TCP westwood registered
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
VFS: Mounted root (squashfs filesystem) readonly on device 31:2.
Freeing unused kernel memory: 140k freed
Please be patient, while OpenWrt loads ...
input: gpio-buttons as /devices/platform/gpio-buttons/input/input0
Button Hotplug driver version 0.3.1
- preinit -
Registered led device: hg255d:power
Registered led device: hg255d:internet
Registered led device: hg255d:wlan
Registered led device: hg255d:usb
Registered led device: hg255d:wps
Registered led device: hg255d:voice
Press the [f] key and hit [enter] to enter failsafe mode
- regular preinit -
jffs2 not ready yet; using ramdisk
mini_fo: using base directory: /
mini_fo: using storage directory: /tmp/root
- init -
Please press Enter to activate this console. NET: Registered protocol family 10
device eth0.1 entered promiscuous mode
device eth0 entered promiscuous mode
br-lan: port 1(eth0.1) entering forwarding state
Compat-wireless backport release: compat-wireless-2011-11-29
Backport based on wireless-testing.git master-2011-12-01
cfg80211: Calling CRDA to update world regulatory domain
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
br-lan: port 1(eth0.1) entering disabled state
br-lan: port 1(eth0.1) entering forwarding state
cfg80211: World regulatory domain updated:
cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
cfg80211: (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
cfg80211: (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
Registered led device: rt2800pci-phy0::radio
Registered led device: rt2800pci-phy0::assoc
Registered led device: rt2800pci-phy0::quality
NTFS driver 2.1.29 [Flags: R/O MODULE].
PPP generic driver version 2.4.2
msdos: Unknown symbol fat_dir_empty
msdos: Unknown symbol fat_time_unix2fat
msdos: Unknown symbol fat_get_dotdot_entry
msdos: Unknown symbol fat_free_clusters
msdos: Unknown symbol fat_setattr
msdos: Unknown symbol fat_scan
msdos: Unknown symbol fat_getattr
msdos: Unknown symbol fat_fs_error
msdos: Unknown symbol fat_attach
msdos: Unknown symbol fat_build_inode
msdos: Unknown symbol fat_fill_super
msdos: Unknown symbol fat_alloc_new_dir
msdos: Unknown symbol fat_remove_entries
msdos: Unknown symbol fat_add_entries
msdos: Unknown symbol fat_sync_inode
msdos: Unknown symbol fat_flush_inodes
msdos: Unknown symbol fat_detach
ip_tables: (C) 2000-2006 Netfilter Core Team
NET: Registered protocol family 24
nf_conntrack version 0.5.0 (470 buckets, 1880 max)
CONFIG_NF_CT_ACCT is deprecated and will be removed soon. Please use
nf_conntrack.acct=1 kernel parameter, acct=1 nf_conntrack module option or
sysctl net.netfilter.nf_conntrack_acct=1 to enable it.
dwc_otg: version 2.72a 24-JUN-2008 (Patched by Lintel 2011)
dwc_otg: Core Release: 2.66a
dwc_otg: Periodic Transfer Interrupt Enhancement - disabled
dwc_otg: Multiprocessor Interrupt Enhancement - disabled
dwc_otg: Using DMA mode
dwc_otg: Device using Buffer DMA mode
dwc_otg dwc_otg.0: DWC OTG Controller
dwc_otg dwc_otg.0: new USB bus registered, assigned bus number 1
dwc_otg dwc_otg.0: irq 26, io mem 0x101c0000
dwc_otg: Init: Port Power? op_state=1
dwc_otg: Init: Power Port (0)
usb usb1: New USB device found, idVendor=1d6b, idProduct=0002
usb usb1: New USB device strings: Mfr=3, Product=2, SerialNumber=1
usb usb1: Product: DWC OTG Controller
usb usb1: Manufacturer: Linux 2.6.32.59 dwc_otg
usb usb1: SerialNumber: dwc_otg.0
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 1 port detected
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
usb 1-1: new high speed USB device using dwc_otg and address 2
fuse init (API version 7.13)
usb 1-1: New USB device found, idVendor=090c, idProduct=1000
usb 1-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
usb 1-1: Product: USB DISK
usb 1-1: Manufacturer: SMI Corporation
usb 1-1: SerialNumber: AA00000000000567
usb 1-1: configuration #1 chosen from 1 choice
scsi0 : SCSI emulation for USB Mass Storage devices
scsi 0:0:0:0: CD-ROM SMI USB DISK 1100 PQ: 0 ANSI: 2
scsi 0:0:0:1: Direct-Access SMI USB DISK 1100 PQ: 0 ANSI: 0 CCS
sd 0:0:0:1: [sda] 14241792 512-byte logical blocks: (7.29 GB/6.79 GiB)
sd 0:0:0:1: [sda] Write Protect is off
sd 0:0:0:1: [sda] Assuming drive cache: write through
sd 0:0:0:1: [sda] Assuming drive cache: write through
sda: sda1 < sda5 >
sd 0:0:0:1: [sda] Assuming drive cache: write through
sd 0:0:0:1: [sda] Attached SCSI disk
attempt to access beyond end of device
sda1: rw=0, want=4, limit=2
EXT3-fs: unable to read superblock
jffs2_scan_eraseblock(): End of filesystem marker found at 0x0
jffs2_build_filesystem(): unlocking the mtd device... done.
jffs2_build_filesystem(): erasing all blocks after the end marker... done.
kjournald starting. Commit interval 5 seconds
EXT3 FS on sda5, internal journal
EXT3-fs: recovery complete.
EXT3-fs: mounted filesystem with writeback data mode.
mini_fo: using base directory: /
mini_fo: using storage directory: /overlay
ramips-wdt: timeout value 60 must be 0 < timeout < 33
|
|
/1 
简体中文
繁體中文
English
日本語
Deutsch
한국 사람
بالعربية
TÜRKÇE
português
คนไทย
IP卡
狗仔卡
发表于 2012-11-24 16:05
置顶卡
沉默卡
喧嚣卡
顶贴卡
显身卡
